Search Linux Wireless

Re: AW: Configuring the multicast data rate with iw/nl80211

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Friday 24 June 2011 14:34:55 Joerg Pommnitz wrote:
> >As an alternative, It's worth a try to look into multicast-to-unicast proxies
> >such as http://sourceforge.net/projects/udpxy/ .
> 
> But then you duplicate the multicast traffic for every STA, no?
Not every STA, only those which subscribed to udpxy at the time.

But there's more, I found it very difficult to "fine-tune" the multicast
setup properly, since there's no automatic feedback for
multicast link quality. Either the rate I picked was too low, or the
signal was too weak, in both cases the video stream as pretty
pretty poor at best.

So I went with the proxy, which as it turns out is a much better
option once you go for 11n. However, the decision is truly yours :D
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Linux ATA RAID]     [Samba]     [Device Mapper]
  Powered by Linux