The Low Power DRPw (LPD) mode contains several optimizations
that designed to reduce power consumption. The purpose
is to save current consumption in RX and Listen mode.
LPD setting apply only for wl127x AP mode (not wl128x)
Signed-off-by: Shahar Levi <shahar_levi@xxxxxx>
---
Changes from v1:
- Remove from configuration parameters and set it as a quirk flag
- DRPW_SET_INI_FILE & DRPW_SET_SCRATCH to
GENERAL_SETTINGS_DRPW_LPD&SCRATCH_ENABLE_LPD
- Move defines to ini.h
drivers/net/wireless/wl12xx/boot.c | 3 +++
drivers/net/wireless/wl12xx/cmd.c | 5 +++++
drivers/net/wireless/wl12xx/ini.h | 3 +++
drivers/net/wireless/wl12xx/main.c | 9 +++++++--
drivers/net/wireless/wl12xx/wl12xx.h | 6 ++++++
5 files changed, 24 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/wl12xx/boot.c b/drivers/net/wireless/wl12xx/boot.c
index b07f8b7..fd35c21 100644
--- a/drivers/net/wireless/wl12xx/boot.c
+++ b/drivers/net/wireless/wl12xx/boot.c
@@ -748,6 +748,9 @@ int wl1271_load_firmware(struct wl1271 *wl)label:mcs.pst-utiles-cisco
clk |= (wl->ref_clock << 1) << 4;
}
+ if (wl->quirks & WL12XX_QUIRK_LPD_MODE)
+ clk |= SCRATCH_ENABLE_LPD;
+
wl1271_write32(wl, DRPW_SCRATCH_START, clk);
wl1271_set_partition(wl, &part_table[PART_WORK]);
diff --git a/drivers/net/wireless/wl12xx/cmd.c b/drivers/net/wireless/wl12xx/cmd.c
index b3a4f58..cdcb324 100644
--- a/drivers/net/wireless/wl12xx/cmd.c
+++ b/drivers/net/wireless/wl12xx/cmd.c
@@ -134,6 +134,11 @@ int wl1271_cmd_general_parms(struct wl1271 *wl)
/* Override the REF CLK from the NVS with the one from platform data */
gen_parms->general_params.ref_clock = wl->ref_clock;
+ /* LPD mode enable (bits 6-7) in WL1271 AP mode only */
+ if (wl->quirks & WL12XX_QUIRK_LPD_MODE)
+ gen_parms->general_params.general_settings |=
+ GENERAL_SETTINGS_DRPW_LPD;
+
ret = wl1271_cmd_test(wl, gen_parms, sizeof(*gen_parms), answer);
if (ret < 0) {
wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed");
diff --git a/drivers/net/wireless/wl12xx/ini.h b/drivers/net/wireless/wl12xx/ini.h
index 1420c84..4cf9ecc 100644
--- a/drivers/net/wireless/wl12xx/ini.h
+++ b/drivers/net/wireless/wl12xx/ini.h
@@ -24,6 +24,9 @@
#ifndef __INI_H__
#define __INI_H__
+#define GENERAL_SETTINGS_DRPW_LPD 0xc0
+#define SCRATCH_ENABLE_LPD BIT(25)
+
#define WL1271_INI_MAX_SMART_REFLEX_PARAM 16
struct wl1271_ini_general_params {
diff --git a/drivers/net/wireless/wl12xx/main.c b/drivers/net/wireless/wl12xx/main.c
index fb0f764..4897191 100644
--- a/drivers/net/wireless/wl12xx/main.c
+++ b/drivers/net/wireless/wl12xx/main.c
@@ -1190,9 +1190,13 @@ static int wl1271_chip_wakeup(struct wl1271 *wl)
wl1271_debug(DEBUG_BOOT, "chip id 0x%x (1271 PG20)",
wl->chip.id);
- /* end-of-transaction flag should be set in wl127x AP mode */
+ /*
+ * 'end-of-transaction flag' and 'LPD mode flag'
+ * should be set in wl127x AP mode only
+ */
if (wl->bss_type == BSS_TYPE_AP_BSS)
- wl->quirks |= WL12XX_QUIRK_END_OF_TRANSACTION;
+ wl->quirks |= (WL12XX_QUIRK_END_OF_TRANSACTION |
+ WL12XX_QUIRK_LPD_MODE);
ret = wl1271_setup(wl);
if (ret < 0)
@@ -1205,6 +1209,7 @@ static int wl1271_chip_wakeup(struct wl1271 *wl)
ret = wl1271_setup(wl);
if (ret < 0)
goto out;
+
if (wl1271_set_block_size(wl))
wl->quirks |= WL12XX_QUIRK_BLOCKSIZE_ALIGNMENT;
break;
diff --git a/drivers/net/wireless/wl12xx/wl12xx.h b/drivers/net/wireless/wl12xx/wl12xx.h
index 1cafb08..bb59cf8 100644
--- a/drivers/net/wireless/wl12xx/wl12xx.h
+++ b/drivers/net/wireless/wl12xx/wl12xx.h
@@ -644,4 +644,10 @@ int wl1271_recalc_rx_streaming(struct wl1271 *wl);
/* WL128X requires aggregated packets to be aligned to the SDIO block size */
#define WL12XX_QUIRK_BLOCKSIZE_ALIGNMENT BIT(2)
+/*
+ * WL127X AP mode requires Low Power DRPw (LPD) enable to reduce power
+ * consumption
+ */
+#define WL12XX_QUIRK_LPD_MODE BIT(3)
+
#endif
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
