On Tue, 2011-04-19 at 03:31 -0700, Lennert Buytenhek wrote: > On Tue, Apr 19, 2011 at 03:38:20PM +0530, Nishant Sarmukadam wrote: > > > > > Timestamp tx packets using a HW micro-second timer. > > > > This timestamp will be compared to the current timestamp > > > > in the hardware and if the difference is greater than 500ms, > > > > the packet will be dropped. > > > > > > Why don't you do this entirely in the firmware? > > > > > > When a packet is put into the TX ring by the host, give it a timestamp > > > of zero. > > > > > > When the firmware gets a TX interrupt, have it walk the TX ring from > > > the last TX entry where a timestamp was written to (i.e. keep a separate > > > index for this), and timestamp all TX ring entries that are marked as > > > being FW OWNED but don't have a timestamp yet (and update your index). > > > > > > Then when the time comes to process the TX packet (i.e. it has reached > > > the head of the TX queue), compare the timestamp with the current time. > > > > Since firmware cannot access host memory directly, it needs additional > > dma operations to read all descriptors, then check the ownership bit and > > update the timestamp for the descriptors. It can easily take about 1us > > per descriptor for this and it can hit the peak throughput by about > > 2.5%. > > That DMA needs to happen anyway, whether you have the host timestamp > the packets or not, so this doesn't seem to be an applicable argument. > Currently, firmware downloads a small fixed number of descriptors at a given time from any tx queue as it does not have memory to download all the descriptors from a host queue. Assume that the total tx buffers available in firmware is X and host tx queue size is 2X and that the host queue is completely backlogged. In this case, the firmware needs to download the descriptors from the head of the host queue to transmit corresponding packets and it needs to download the descriptors at the tail of the host queue to timestamp them. But, firmware cannot transmit the packets associated with descriptors from the tail since there are packets in host queue which were queued earlier to these packets. This effectively results in each descriptor being downloaded twice - once for timestamp and once for transmission. This will significantly affect the peak throughput performance. > > > Also, when the firmware is processing the packets from the host tx > > queues, it keeps the host interrupt for tx packets disabled to avoid > > unnecessary interruptions. Hence, the timestamp in the firmware can > > deviate from when the packet was queued in the host queue. > > Right, but that is an (easily fixable?) implementation detail, and not > a reason for why this fundamentally cannot work. Disabling the interrupts is a MIPS optimization. If we enable the interrupts, it would result in lot of interrupts and context switches which will add to processing overhead and reduce peak throughput. > > > > > As an added bonus, this'll also work over USB/SPI/whatever other bus > > > type where you cannot read some H/W microsecond timestamp register > > > directly like you can on PCI(e) -- which sticks out like a sore thumb > > > because it goes around the clean command / ring based host<->firmware > > > interface. > > > > We agree that this approach will not work without additional changes > > for non-PCI devices. However, we do not foresee such devices being > > supported by mwl8k in the near future. > > It's still an ugly layering violation, IMHO. But if MRVL is OK with it... -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
