On Wed, Apr 13, 2011 at 9:56 PM, Felix Fietkau <nbd@xxxxxxxxxxx> wrote:
> On a dual-radio dual-band AR5312 device, the calibration data is shared
> between the 5 GHz and the 2.4 GHz radio/MAC.
>
> Signed-off-by: Felix Fietkau <nbd@xxxxxxxxxxx>
> ---
Tested all 5 patches against "freaky" linux-next (next-20110414).
Feel free to add:
Tested-by: Sedat Dilek <sedat.dilekÅgmail.com>
- Sedat -
P.S.: Attach dmesg and lspci outputs
# dmesg | egrep -i 'ath|80211|wlan|crda'
[ 4.784132] cfg80211: Calling CRDA to update world regulatory domain
[ 5.004594] ath5k 0000:02:02.0: PCI INT A -> Link[LNKC] -> GSI 11
(level, low) -> IRQ 11
[ 5.004709] ath5k 0000:02:02.0: registered as 'phy0'
[ 5.294992] ath: EEPROM regdomain: 0x61
[ 5.294996] ath: EEPROM indicates we should expect a direct regpair map
[ 5.295002] ath: Country alpha2 being used: 00
[ 5.295004] ath: Regpair used: 0x61
[ 5.506881] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[ 5.507770] Registered led device: ath5k-phy0::rx
[ 5.507800] Registered led device: ath5k-phy0::tx
[ 5.507813] ath5k phy0: Atheros AR5212 chip found (MAC: 0x56, PHY: 0x41)
[ 5.507857] ath5k phy0: RF5111 5GHz radio found (0x17)
[ 5.507893] ath5k phy0: RF2111 2GHz radio found (0x23)
[ 8.297097] cfg80211: World regulatory domain updated:
[ 8.297149] cfg80211: (start_freq - end_freq @ bandwidth),
(max_antenna_gain, max_eirp)
[ 8.299903] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz),
(300 mBi, 2000 mBm)
[ 8.299950] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz),
(300 mBi, 2000 mBm)
[ 8.299997] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz),
(300 mBi, 2000 mBm)
[ 8.300057] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz),
(300 mBi, 2000 mBm)
[ 8.300104] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz),
(300 mBi, 2000 mBm)
[ 12.303413] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 17.690110] wlan0: authenticate with 00:04:0e:e4:00:3d (try 1)
[ 17.691907] wlan0: authenticated
[ 17.691974] wlan0: associate with 00:04:0e:e4:00:3d (try 1)
[ 17.698281] wlan0: RX AssocResp from 00:04:0e:e4:00:3d (capab=0x411
status=0 aid=1)
[ 17.698293] wlan0: associated
[ 17.700380] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 28.424062] wlan0: no IPv6 routers present
# lspci -nnvv -s 02:02.0
02:02.0 Ethernet controller [0200]: Atheros Communications Inc. AR5212
802.11abg NIC [168c:1014] (rev 01)
Subsystem: Phillips Components Device [17ab:8331]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 11
Region 0: Memory at c0210000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=2 PME-
Kernel driver in use: ath5k
- EOT -
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
