From: Sujith Manoharan <Sujith.Manoharan@xxxxxxxxxxx> Commit "ath9k_hw: Relocate Opmode initialization" moved the opmode initialization before the STA_ID1 register was programmed with defaults. This changed the original behaviour because the re-programming code doesn't take into account the existing value in the register. Both ath9k and ath9k_htc were not affected by this change because the opmode is re-initialized after every reset, when RX is started. Revert to the original behavior, except keep it outside the REGWRITE block. This would help remove extraneous opmode calls in the driver core. Signed-off-by: Sujith Manoharan <Sujith.Manoharan@xxxxxxxxxxx> --- drivers/net/wireless/ath/ath9k/hw.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/net/wireless/ath/ath9k/hw.c b/drivers/net/wireless/ath/ath9k/hw.c index 4615fd9..c340851 100644 --- a/drivers/net/wireless/ath/ath9k/hw.c +++ b/drivers/net/wireless/ath/ath9k/hw.c @@ -1349,8 +1349,6 @@ int ath9k_hw_reset(struct ath_hw *ah, struct ath9k_channel *chan, ath9k_hw_spur_mitigate_freq(ah, chan); ah->eep_ops->set_board_values(ah, chan); - ath9k_hw_set_operating_mode(ah, ah->opmode); - ENABLE_REGWRITE_BUFFER(ah); REG_WRITE(ah, AR_STA_ID0, get_unaligned_le32(common->macaddr)); @@ -1368,6 +1366,8 @@ int ath9k_hw_reset(struct ath_hw *ah, struct ath9k_channel *chan, REGWRITE_BUFFER_FLUSH(ah); + ath9k_hw_set_operating_mode(ah, ah->opmode); + r = ath9k_hw_rf_set_freq(ah, chan); if (r) return r; -- 1.7.3.5 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
