Usually you set RTL818X_CONFIG3_ANAPARAM_WRITE when you are going to change/write ANAPARAM registers. But in current initialization of RTL8187B there is a place where ANAPARAM_WRITE bit is set without any ANAPARAM register being written, without reason, so remove it. Signed-off-by: Herton Ronaldo Krzesinski <herton@xxxxxxxxxxxxxxx> Acked-by: Larry Finger <Larry.Finger@xxxxxxxxxxxx> Cc: seno <senada@xxxxxxxxxxx> --- drivers/net/wireless/rtl818x/rtl8187_dev.c | 8 -------- 1 files changed, 0 insertions(+), 8 deletions(-) diff --git a/drivers/net/wireless/rtl818x/rtl8187_dev.c b/drivers/net/wireless/rtl818x/rtl8187_dev.c index c0c75aa..4448647 100644 --- a/drivers/net/wireless/rtl818x/rtl8187_dev.c +++ b/drivers/net/wireless/rtl818x/rtl8187_dev.c @@ -814,14 +814,6 @@ static int rtl8187b_init_hw(struct ieee80211_hw *dev) /* RFSW_CTRL register */ rtl818x_iowrite16_idx(priv, (__le16 *)0xFF72, 0x569A, 2); - rtl818x_iowrite8(priv, &priv->map->EEPROM_CMD, - RTL818X_EEPROM_CMD_CONFIG); - reg = rtl818x_ioread8(priv, &priv->map->CONFIG3); - reg |= RTL818X_CONFIG3_ANAPARAM_WRITE; - rtl818x_iowrite8(priv, &priv->map->CONFIG3, reg); - rtl818x_iowrite8(priv, &priv->map->EEPROM_CMD, - RTL818X_EEPROM_CMD_NORMAL); - rtl818x_iowrite16(priv, &priv->map->RFPinsOutput, 0x0480); rtl818x_iowrite16(priv, &priv->map->RFPinsSelect, 0x2488); rtl818x_iowrite16(priv, &priv->map->RFPinsEnable, 0x1FFF); -- 1.7.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
