Hi all, Rate control for A-MPDU is somewhat complicated, mainly because each subframe has its own tx status but rate control is only relevant on a per aggregate level. This patch series fixes some more obscure bugs in the rate control feedback for A-MPDU frames, mainly for the case when rate control feedback is carried on a frame that has failed transmission. There are two underlying assumptions: (1) the ampdu_len and ampdu_ack_len fields of the tx status structure must be set correctly by the driver if the IEEE80211_TX_STAT_AMPDU flag is set, and (2) the value of these fields must not be relied upon by rate control if the flag is not set. I've only been able to test these patches with the ath9k driver using the minstrel ht rate control algorithm. I have also looked at the other driver references to ampdu_len and they seem safe under the above assumptions, except ath9k's built in rate control, for which I've attempted a fix. Björn Smedman (3): mac80211: minstrel_ht A-MPDU fix ath9k: A-MPDU rate control info fix ath9k: built-in rate control A-MPDU fix drivers/net/wireless/ath/ath9k/rc.c | 6 ++++++ drivers/net/wireless/ath/ath9k/xmit.c | 19 +++++++++++++------ net/mac80211/rc80211_minstrel_ht.c | 7 ++++--- 3 files changed, 23 insertions(+), 9 deletions(-) /Björn
