On 2010-07-26 7:10 PM, Björn Smedman wrote: > Hi all, > > I've been running a lot of iperf on AR913x / > compat-wireless-2010-07-16 (w/ openwrt/trunk@22388). > > I think there are some (in theory) simple improvements that can be > done to the tx aggregation / rate control logic. A proof of concept of > one such improvement is provided below. Basically, it's a hack that > makes ath9k output aggregates with only the first rate in the rate > series. The reasoning is that a failure is not a problem for > aggregates because there is software retry. Retrying in hardware at a > slower rate is counter productive. So, better to fail and do a > software retry at possibly another rate. Also, since the aggregate > size is often limited by the slowest rate in the MRR series (4 ms txop > limit) having a slow rate in the series may affect performance even if > it is never used by the hardware. > > In my (not so scientific) tests max AP downstream throughput increases > about 30-40% with the patch below (from 33.9 to 55.7 Mbit/s with HT20 > in noisy environment with 20 meters and a few walls between AP and > client). > > Of course, if all rates in the series are high then this patch has no effect. I think it makes sense to rely less on on-chip MRR for fallback, but I think to make this workable, we really should use the MRR table for something, otherwise the rate control algorithm will take much longer to adapt. It's probably better to fix this properly after I'm done with my A-MPDU rewrite, because then I can more easily push parts of the software retransmission behaviour into minstrel_ht directly. - Felix -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
