From: Wey-Yi Guy <wey-yi.w.guy@xxxxxxxxx>
This bit need to be set for both RTS/CTS or CTS-to-self protection, if
CTS-to-self is used, then uCode will check the RXON_FLG_SELF_CTS_EN
status. Change the name from TX_CMD_FLG_RTS_CTS_MSK to TX_CMD_FLAG_PROT_REQUIRE_MSK
to match the behavior of the bit setting.
Also update comments to reflect which hardware uses which of the TX command
flags.
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@xxxxxxxxx>
Signed-off-by: Reinette Chatre <reinette.chatre@xxxxxxxxx>
---
drivers/net/wireless/iwlwifi/iwl-agn-hcmd.c | 2 +-
drivers/net/wireless/iwlwifi/iwl-commands.h | 30 ++++++++++++++++++--------
2 files changed, 22 insertions(+), 10 deletions(-)
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-hcmd.c b/drivers/net/wireless/iwlwifi/iwl-agn-hcmd.c
index d89a11c..f06d1fe 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn-hcmd.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn-hcmd.c
@@ -214,7 +214,7 @@ static void iwlagn_chain_noise_reset(struct iwl_priv *priv)
static void iwlagn_rts_tx_cmd_flag(struct ieee80211_tx_info *info,
__le32 *tx_flags)
{
- *tx_flags |= TX_CMD_FLG_RTS_CTS_MSK;
+ *tx_flags |= TX_CMD_FLG_PROT_REQUIRE_MSK;
}
/* Calc max signal level (dBm) among 3 possible receivers */
diff --git a/drivers/net/wireless/iwlwifi/iwl-commands.h b/drivers/net/wireless/iwlwifi/iwl-commands.h
index 4984925..a304f77 100644
--- a/drivers/net/wireless/iwlwifi/iwl-commands.h
+++ b/drivers/net/wireless/iwlwifi/iwl-commands.h
@@ -1399,18 +1399,27 @@ struct iwl_rx_mpdu_res_start {
/* REPLY_TX Tx flags field */
-/* 1: Use RTS/CTS protocol or CTS-to-self if spec allows it
+/*
+ * 1: Use RTS/CTS protocol or CTS-to-self if spec allows it
* before this frame. if CTS-to-self required check
- * RXON_FLG_SELF_CTS_EN status. */
-#define TX_CMD_FLG_RTS_CTS_MSK cpu_to_le32(1 << 0)
+ * RXON_FLG_SELF_CTS_EN status.
+ * unused in 3945/4965, used in 5000 series and after
+ */
+#define TX_CMD_FLG_PROT_REQUIRE_MSK cpu_to_le32(1 << 0)
-/* 1: Use Request-To-Send protocol before this frame.
- * Mutually exclusive vs. TX_CMD_FLG_CTS_MSK. */
+/*
+ * 1: Use Request-To-Send protocol before this frame.
+ * Mutually exclusive vs. TX_CMD_FLG_CTS_MSK.
+ * used in 3945/4965, unused in 5000 series and after
+ */
#define TX_CMD_FLG_RTS_MSK cpu_to_le32(1 << 1)
-/* 1: Transmit Clear-To-Send to self before this frame.
+/*
+ * 1: Transmit Clear-To-Send to self before this frame.
* Driver should set this for AUTH/DEAUTH/ASSOC-REQ/REASSOC mgmnt frames.
- * Mutually exclusive vs. TX_CMD_FLG_RTS_MSK. */
+ * Mutually exclusive vs. TX_CMD_FLG_RTS_MSK.
+ * used in 3945/4965, unused in 5000 series and after
+ */
#define TX_CMD_FLG_CTS_MSK cpu_to_le32(1 << 2)
/* 1: Expect ACK from receiving station
@@ -1430,8 +1439,11 @@ struct iwl_rx_mpdu_res_start {
* Set when Txing a block-ack request frame. Also set TX_CMD_FLG_ACK_MSK. */
#define TX_CMD_FLG_IMM_BA_RSP_MASK cpu_to_le32(1 << 6)
-/* 1: Frame requires full Tx-Op protection.
- * Set this if either RTS or CTS Tx Flag gets set. */
+/*
+ * 1: Frame requires full Tx-Op protection.
+ * Set this if either RTS or CTS Tx Flag gets set.
+ * used in 3945/4965, unused in 5000 series and after
+ */
#define TX_CMD_FLG_FULL_TXOP_PROT_MSK cpu_to_le32(1 << 7)
/* Tx antenna selection field; used only for 3945, reserved (0) for 4965.
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
