As far as we know, only NF calibration interferes with RX/TX so we can leave the queues enabled for the other calibrations. BTW: Stopping the queues is not enough for avoiding transmissions, since there might be packets in the queue + beacons are also sent regularly! But i leave it like this until we have a better solution (stopping TX DMA?). Signed-off-by: Bruno Randolf <br1@xxxxxxxxxxx> --- drivers/net/wireless/ath/ath5k/base.c | 11 ++++++----- 1 files changed, 6 insertions(+), 5 deletions(-) diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c index 8bc970f..b15b9d6 100644 --- a/drivers/net/wireless/ath/ath5k/base.c +++ b/drivers/net/wireless/ath/ath5k/base.c @@ -2784,10 +2784,6 @@ ath5k_tasklet_calibrate(unsigned long data) /* Only full calibration for now */ ah->ah_cal_mask |= AR5K_CALIBRATION_FULL; - /* Stop queues so that calibration - * doesn't interfere with tx */ - ieee80211_stop_queues(sc->hw); - ATH5K_DBG(sc, ATH5K_DEBUG_CALIBRATE, "channel %u/%x\n", ieee80211_frequency_to_channel(sc->curchan->center_freq), sc->curchan->hw_value); @@ -2805,8 +2801,13 @@ ath5k_tasklet_calibrate(unsigned long data) ieee80211_frequency_to_channel( sc->curchan->center_freq)); + /* TODO: We don't need to run noise floor calibration as often + * as I/Q calibration.*/ + + /* Noise floor calibration interrupts rx/tx path while I/Q calibration + * doesn't. Stop queues so that calibration doesn't interfere with tx */ + ieee80211_stop_queues(sc->hw); ath5k_hw_update_noise_floor(ah); - /* Wake queues */ ieee80211_wake_queues(sc->hw); ah->ah_cal_mask &= ~AR5K_CALIBRATION_FULL; -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
