From: Saravanan Dhanabal <ext-saravanan.dhanabal@xxxxxxxxx> After last transmission, the device goes to sleep earlier than the configured dynamic power save timeout. If timeout is set to 400ms, device enters into sleep mode at around 330ms since from last TX. This patch removes the msleep(1), which causes the delay after ELP wakeup. Replaced with udelay(10), the variation is around 7-10ms. Signed-off-by: Saravanan Dhanabal <ext-saravanan.dhanabal@xxxxxxxxx> Reviewed-by: Juuso Oikarinen <juuso.oikarinen@xxxxxxxxx> Signed-off-by: Luciano Coelho <luciano.coelho@xxxxxxxxx> --- drivers/net/wireless/wl12xx/wl1271_cmd.c | 9 ++++++++- 1 files changed, 8 insertions(+), 1 deletions(-) diff --git a/drivers/net/wireless/wl12xx/wl1271_cmd.c b/drivers/net/wireless/wl12xx/wl1271_cmd.c index 0cb4cbb..f11f9f4 100644 --- a/drivers/net/wireless/wl12xx/wl1271_cmd.c +++ b/drivers/net/wireless/wl12xx/wl1271_cmd.c @@ -36,6 +36,8 @@ #include "wl1271_cmd.h" #include "wl1271_event.h" +#define WL1271_CMD_POLL_COUNT 5 + /* * send command to firmware * @@ -52,6 +54,7 @@ int wl1271_cmd_send(struct wl1271 *wl, u16 id, void *buf, size_t len, u32 intr; int ret = 0; u16 status; + u16 poll_count = 0; cmd = buf; cmd->id = cpu_to_le16(id); @@ -73,7 +76,11 @@ int wl1271_cmd_send(struct wl1271 *wl, u16 id, void *buf, size_t len, goto out; } - msleep(1); + udelay(10); + poll_count++; + if (poll_count == WL1271_CMD_POLL_COUNT) + wl1271_info("cmd polling took over %d cycles", + poll_count); intr = wl1271_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR); } -- 1.6.3.3 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html