Hello, I have 3 Dell 1450 Wireless USB adapters, and 2 of them give me issues with 'unknown rssi calibration data packing'. Should I just report it here? usb 2-2: new full speed USB device using uhci_hcd and address 4 usb 2-2: not running at top speed; connect to a high speed hub usb 2-2: configuration #1 chosen from 1 choice usb 2-2: reset full speed USB device using uhci_hcd and address 4 usb 2-2: firmware: requesting isl3887usb phy2: p54 detected a LM87 firmware p54: rx_mtu reduced from 3240 to 2384 phy2: FW rev 2.13.24.0 - Softmac protocol 5.9 phy2: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES phy2: unknown rssi calibration data packing type:(1908) len:14. rssical:00 00 8f 09 87 00 71 fe 78 14 81 00 7c fe ......q.x...|. phy2: please report this issue. phy2: hwaddr 00:14:a5:95:5e:78, MAC:isl3892 RF:Xbow phy2: Selected rate control algorithm 'minstrel' Registered led device: p54-phy2::assoc Registered led device: p54-phy2::tx Registered led device: p54-phy2::rx Registered led device: p54-phy2::radio usb 2-2: is registered as 'phy2' udev: renamed network interface wlan0 to wlan3 usb 2-2: USB disconnect, address 4 usb 2-2: new full speed USB device using uhci_hcd and address 5 usb 2-2: not running at top speed; connect to a high speed hub usb 2-2: configuration #1 chosen from 1 choice usb 2-2: reset full speed USB device using uhci_hcd and address 5 usb 2-2: firmware: requesting isl3887usb phy3: p54 detected a LM87 firmware p54: rx_mtu reduced from 3240 to 2384 phy3: FW rev 2.13.24.0 - Softmac protocol 5.9 phy3: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES phy3: unknown rssi calibration data packing type:(1908) len:14. rssical:00 00 8f 09 85 00 76 fe 78 14 81 00 7c fe ......v.x...|. phy3: please report this issue. phy3: hwaddr 00:14:a5:d0:0a:1a, MAC:isl3892 RF:Xbow phy3: Selected rate control algorithm 'minstrel' Registered led device: p54-phy3::assoc Registered led device: p54-phy3::tx Registered led device: p54-phy3::rx Registered led device: p54-phy3::radio usb 2-2: is registered as 'phy3' udev: renamed network interface wlan0 to wlan1 usb 2-2: USB disconnect, address 5 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
