On Friday 06 November 2009 18:00:54 James Grossmann wrote: > It connects up with the patch! > I'll attach a dmesg for any info you might be able to glean from that. > THANKS! it's a start, but there are some serious implications. but first: what is your signal (dBm) reading (iwconfig / iw dev wlanX info)? I'm asking this because your device is only fine-tunable for channel 1, 7, 13 & 14 with the current data points. some performance figures would be nice as well. e.g.: iperf (tcp) should be > 18Mbit/s, if you are close & free line of sight second: what should we do about these devices? Surely, the best thing would be to simply reprogram the eeprom, but this (being complicated work) requires soldering skills/tools, a steady hand and enough boredom. Therefor this is likely the least ideal option to put into the WIKI @ wireless.kernel.org . Any suitable ideas? Regards, Chr --- > [ 5593.622225] cfg80211: Calling CRDA to update world regulatory > domain > [ 5593.756965] p54pci 0000:03:00.0: PCI INT A -> Link[LNKA] -> GSI 11 > (level, low) -> IRQ 11 > [ 5593.757087] p54pci 0000:03:00.0: firmware: requesting isl3886pci > [ 5593.799682] cfg80211: World regulatory domain updated: > [ 5593.799693] (start_freq - end_freq @ bandwidth), > (max_antenna_gain, max_eirp) > [ 5593.799701] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, > 2000 mBm) > [ 5593.799708] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, > 2000 mBm) > [ 5593.799714] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, > 2000 mBm) > [ 5593.799721] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) > [ 5593.799728] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) > [ 5593.826106] phy0: p54 detected a LM86 firmware > [ 5593.826115] p54: rx_mtu reduced from 3240 to 2376 > [ 5593.826121] phy0: FW rev 2.13.12.0 - Softmac protocol 5.9 > [ 5593.826127] phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES > [ 5593.943095] phy0: hwaddr 00:xx:xx:xx:xx:xx, MAC:isl3880 RF:Frisbee > > [ 5593.943532] phy0: Selected rate control algorithm 'minstrel' > [ 5593.945386] Registered led device: p54-phy0::assoc > [ 5593.945426] Registered led device: p54-phy0::tx > [ 5593.945466] Registered led device: p54-phy0::rx > [ 5593.945507] Registered led device: p54-phy0::radio > [ 5593.945521] p54pci 0000:03:00.0: is registered as 'phy0' > [ 5593.973148] udev: renamed network interface wlan0 to wlan1 > [ 5594.105670] ADDRCONF(NETDEV_UP): wlan1: link is not ready > [ 5601.380939] wlan1: deauthenticating from 00:xx:xx:xx:xx:xx by local > choice (reason=3) > [ 5601.381046] wlan1: direct probe to AP 00:xx:xx:xx:xx:xx (try 1) > [ 5601.385723] wlan1: direct probe responded > [ 5601.385738] wlan1: authenticate with AP 00:xx:xx:xx:xx:xx (try 1) > [ 5601.387961] wlan1: authenticated > [ 5601.388049] wlan1: associate with AP 00:xx:xx:xx:xx:xx (try 1) > [ 5601.390237] wlan1: RX AssocResp from 00:xx:xx:xx:xx:xx (capab=0x401 > status=0 aid=2) > [ 5601.390246] wlan1: associated > [ 5601.391891] ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready > [ 5612.024163] wlan1: no IPv6 routers present > -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html