On Wed, 2009-08-26 at 03:43 +0100, Hin-Tak Leung wrote: > The rfkill event hard just goes 1 and 0 whenever I slide the switch, > regardless of what NM does . e.g. NM set to disable networking has no > effect on the 1/0 switch (it happens just depending on the slide > switch and nothing else), and nothing changes when NM noticed > rfkill'ed if down & decided to if'up and reassociate. Right, I just wanted to make sure the switch could be correctly read while the interface is down. > Basically the rfkill event state just depends on the slide switch, > regardless of NM (if it is set to enable wireless networking, it just > if up the device again; if it is set to disable, it just stayed > disable & the device stay down, but the event state continues to > respond to the slide switch). Ok. But this isn't making a lot of sense to me, since cfg80211 should refuse to UP the device when it's rfkilled. Or wait ... are you using compat-wireless? johannes
Attachment:
signature.asc
Description: This is a digitally signed message part
