On Sat, Apr 25, 2009 at 1:31 PM, Alf <alf@xxxxxxxxxx> wrote: > I have a D-Link PCI card with a ADM8211 driver: > > 00:07.0 Network controller: ADMtek ADM8211 802.11b Wireless Interface > (rev 11) > > A few years ago I used it in Linux with the out-of-tree driver without any > problems. I now have need of the card again in Linux, but the card doesn't > want to associate with the AP. I tried the card under Windows and it worked > well, so I know it's not hardware or configuration issues. > > I am using kernel 2.6.29.1 with version 29 of the wireless_tools package and > wpa_supplicant 0.6.9. I have disabled wpa_supplicant and have tried > configuring the card directly with iwconfig: > > iwconfig wlan0 essid (ssid) channel 1 mode managed \ > key (some hex junk) > > In the end, iwconfig reports: > > wlan0 IEEE 802.11b ESSID:"(ssid)" > Mode:Managed Frequency:2.412 GHz Access Point: Not-Associated > Tx-Power=27 dBm > Retry min limit:7 RTS thr:off Fragment thr=2352 B > Encryption key:(some hex junk) Security mode:open > Power Management:off > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > There are a few weird things I'm observing: > > - The signal level and noise level are both at 0. > > - Even when scanning, the signal strength is very low even though the AP is > 4 feet away (Quality=0/100 Signal level:19/100). Windows reports a strong > signal. > > - The kernel log only reports the following problems: > > Apr 25 11:22:17 xyz wlan0: direct probe to AP 00:30:bd:60:d3:44 try 1 > Apr 25 11:22:17 xyz wlan0: direct probe to AP 00:30:bd:60:d3:44 try 2 > Apr 25 11:22:18 xyz wlan0: direct probe to AP 00:30:bd:60:d3:44 try 3 > Apr 25 11:22:18 xyz wlan0: direct probe to AP 00:30:bd:60:d3:44 timed out > > (the AP mac address is correct) > > - When the card is loaded, there is a significant pause (about 15 seconds) > when I first try to do something with the card. For example, if I load the > module and use iwconfig as outlined above and then run iwconfig again to see > the configuration, it takes about 15 or 16 seconds for it to display. Also, > if any services (like ssh) want to bind the address when it first comes up, > sshd takes about 15 seconds to start. But, once this delay has happened, > everything else works fine. For example, if I run iwconfig again, it > displays the information immediately. > > Would any of you have any pointers on how to debug the problem with this > card and fix it? I'm running a custom kernel, so I can reconfigure or patch > as necessary. (Distribution is Linux From Scratch; all other similar > systems with wireless networking work just fine.) May want to try wireless-testing or compat-wireless to see if the issue is still present. This driver is old and the maintainer is no longer active so your best bet is to try the latest and see if someone is willing to help you with random bits of troubleshooting. Luis -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
