ieee80211_tx_h_check_assoc() was dropping everything else than probe requests during software scan. So the null frame with the power save bit was dropped and AP never received it. This meant that AP never buffered any frames for the station during software scan. Fix this by allowing to transmit both probe request and null frames during software scan. Tested with stlc45xx. Signed-off-by: Kalle Valo <kalle.valo@xxxxxxxxx> --- net/mac80211/scan.c | 5 +++++ net/mac80211/tx.c | 9 ++++++++- 2 files changed, 13 insertions(+), 1 deletions(-) diff --git a/net/mac80211/scan.c b/net/mac80211/scan.c index 0e81e16..fae18c3 100644 --- a/net/mac80211/scan.c +++ b/net/mac80211/scan.c @@ -397,6 +397,11 @@ int ieee80211_start_scan(struct ieee80211_sub_if_data *scan_sdata, return 0; } + /* + * While local->sw_scanning is true everything else but null + * frames and probe requests will be dropped in + * ieee80211_tx_h_check_assoc(). + */ local->sw_scanning = true; if (local->ops->sw_scan_start) local->ops->sw_scan_start(local_to_hw(local)); diff --git a/net/mac80211/tx.c b/net/mac80211/tx.c index c3f0e95..bfe6ecd 100644 --- a/net/mac80211/tx.c +++ b/net/mac80211/tx.c @@ -193,7 +193,14 @@ ieee80211_tx_h_check_assoc(struct ieee80211_tx_data *tx) return TX_CONTINUE; if (unlikely(tx->local->sw_scanning) && - !ieee80211_is_probe_req(hdr->frame_control)) + !ieee80211_is_probe_req(hdr->frame_control) && + !ieee80211_is_nullfunc(hdr->frame_control)) + /* + * When software scanning only null frames (to notify the + * sleep state to the AP) and probe requests (for the + * active scan) are allowed, everything else should be + * dropped. + */ return TX_DROP; if (tx->sdata->vif.type == NL80211_IFTYPE_MESH_POINT) -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html