Hi All,
My actually Sydtem is:
HP Pavilion Laptop zv5000
Debian Lenny(Testing)
Linux Kernel 2.6.28 from kernel.org
Broadcom Wlan card BCM4303
My System doesnt work at all.
My Boot Messages are:
[ 21.331095] b43legacy-phy0: Broadcom 4301 WLAN found
[ 21.412214] b43legacy-phy0 debug: Found PHY: Analog 0, Type 1, Revision 4
[ 21.412240] b43legacy-phy0 debug: Found Radio: Manuf 0x17F, Version
0x2050, Revision 2
[ 21.436305] b43legacy-phy0 debug: Radio initialized
[ 40.529192] input: b43legacy-phy0 as /class/input/input9
[ 40.632070] b43legacy ssb0:0: firmware: requesting b43legacy/ucode2.fw
[ 40.696281] b43legacy ssb0:0: firmware: requesting b43legacy/pcm4.fw
[ 40.757265] b43legacy ssb0:0: firmware: requesting
b43legacy/b0g0initvals2.fw
[ 40.984045] b43legacy-phy0: Loading firmware version 0x127, patch
level 14 (2005-04-18 02:36:27)
[ 41.100298] b43legacy-phy0 debug: Chip initialized
[ 41.100599] b43legacy-phy0 debug: 30-bit DMA initialized
[ 41.100748] Registered led device: b43legacy-phy0:tx
[ 41.109182] Registered led device: b43legacy-phy0:rx
[ 41.117508] Registered led device: b43legacy-phy0:radio
[ 41.125678] b43legacy-phy0 debug: Wireless interface started
[ 41.125685] b43legacy-phy0 debug: Adding Interface type 2
[ 41.584048] b43legacy-phy0: Radio hardware status changed to DISABLED
[ 41.593709] b43legacy-phy0 debug: Radio initialized
[ 41.924035] b43legacy-phy0: Radio turned on by software
[ 41.932354] b43legacy-phy0: The hardware RF-kill button still turns
the radio physically off. Press the button to turn it on.
Actually i am looking whether i missing some Kernel
Options.
As we can see in the Boot Messages i have to activate the RF-kill
Button by pressing, but this does not activate my wlan.
Any Ideas?
Regards Markus
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
