On 2/7/2025 10:33 AM, Aaradhana Sahu wrote:
When multi-link operation(MLO) is enabled through follow-up patches in the single split-phy device, the firmware expects hardware links (hw_links) information from the driver. If driver does not send WMI multi-link setup and ready command to the firmware during MLO setup for single split-phy device, the firmware will be unaware of the hw_links component of the multi-link operation. This may lead to firmware assert during multi-link association. Therefore, enable WMI setup, ready and teardown commands for single split-phy PCI device. Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1 Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 Signed-off-by: Aaradhana Sahu <quic_aarasahu@xxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
