Currently, peer id get reported in the PPDU end user TLV tag. But the
monitor status handler is inherited from ath11k, but it was not updated
to incorporate the changes made to ath12k 802.11be hardware architecture.
Therefore, update the peer id from the PPDU end user TLV data to get latest
peer id update, it helps to populate accurate peer information on the
statistics data.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
Co-developed-by: P Praneesh <quic_ppranees@xxxxxxxxxxx>
Signed-off-by: P Praneesh <quic_ppranees@xxxxxxxxxxx>
Signed-off-by: Karthikeyan Periyasamy <quic_periyasa@xxxxxxxxxxx>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@xxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath12k/dp_mon.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/net/wireless/ath/ath12k/dp_mon.c b/drivers/net/wireless/ath/ath12k/dp_mon.c
index f4552bc05eef..c4c5db5d5ffb 100644
--- a/drivers/net/wireless/ath/ath12k/dp_mon.c
+++ b/drivers/net/wireless/ath/ath12k/dp_mon.c
@@ -1504,6 +1504,9 @@ ath12k_dp_mon_rx_parse_status_tlv(struct ath12k *ar,
ppdu_info->num_mpdu_fcs_err =
u32_get_bits(info[0],
HAL_RX_PPDU_END_USER_STATS_INFO0_MPDU_CNT_FCS_ERR);
+ ppdu_info->peer_id =
+ u32_get_bits(info[0], HAL_RX_PPDU_END_USER_STATS_INFO0_PEER_ID);
+
switch (ppdu_info->preamble_type) {
case HAL_RX_PREAMBLE_11N:
ppdu_info->ht_flags = 1;
--
2.34.1
