On 1/25/25 00:23, Ramya Gnanasekar wrote:
Add support to request pdev stats from firmware through WMI and
print the information
Sample Output:
-------------
cat /sys/kernel/debug/ath12k/pci-0000\:06\:00.0/mac0/fw_stats/pdev_stats
ath12k PDEV stats
=================
Channel noise floor -85
Channel TX power 126
TX frame count 0
RX frame count 8637
RX clear count 37424
Cycle count 4372024
PHY error count 0
soc drop count 0
ath12k PDEV TX stats
====================
HTT cookies queued 0
HTT cookies disp. 0
MSDU queued 0
MPDU queued 0
MSDUs dropped 0
Local enqued 0
Local freed 0
HW queued 0
PPDUs reaped 0
Num underruns 0
PPDUs cleaned 0
MPDUs requeued 0
Excessive retries 0
HW rate 0
Sched self triggers 0
Dropped due to SW retries 0
Illegal rate phy errors 0
PDEV continuous xretry 0
TX timeout 9
PDEV resets 0
Stateless TIDs alloc failures 0
PHY underrun 0
MPDU is more than txop limit 0
ath12k PDEV RX stats
====================
Mid PPDU route change 0
Tot. number of statuses 0
Extra frags on rings 0 0
Extra frags on rings 1 0
Extra frags on rings 2 0
Extra frags on rings 3 0
MSDUs delivered to HTT 0
MPDUs delivered to HTT 0
MSDUs delivered to stack 0
MPDUs delivered to stack 0
Oversized AMSUs 0
PHY errors 0
PHY errors drops 0
MPDU errors (FCS, MIC, ENC) 0
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
Signed-off-by: Ramya Gnanasekar<ramya.gnanasekar@xxxxxxxxxxxxxxxx>
---
Reviewed-by: Aditya Kumar Singh <aditya.kumar.singh@xxxxxxxxxxxxxxxx>
--
Aditya
