Currently, ath12k_core_pre_reconfigure_recovery() reconfigures all radios
within the same group. During grouping and driver going for a recovery,
this function is called as many times as there are devices in the group.
Consequently, it performs the same reconfiguration multiple times, which
is unnecessary.
To prevent this, add a check to continue if the action has already been
taken.
To simplify the management of various flags, the reason for hardware queues
being stopped is used as a check instead of introducing a new flag.
While at it, also add missing wiphy locks. Wiphy lock is required since
ath12k_mac_drain_tx() which is called by
ath12k_core_pre_reconfigure_recovery() needs this lock to be held by the
caller.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1
Signed-off-by: Aditya Kumar Singh <quic_adisi@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath12k/core.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/net/wireless/ath/ath12k/core.c b/drivers/net/wireless/ath/ath12k/core.c
index 72e6e3a0cf7be03b20b7421866c479dfcb8038ff..5700fc661ac380b6c01d0571595d27fb1ab7c8c5 100644
--- a/drivers/net/wireless/ath/ath12k/core.c
+++ b/drivers/net/wireless/ath/ath12k/core.c
@@ -1279,6 +1279,18 @@ static void ath12k_core_pre_reconfigure_recovery(struct ath12k_base *ab)
if (!ah || ah->state == ATH12K_HW_STATE_OFF)
continue;
+ wiphy_lock(ah->hw->wiphy);
+
+ /* If queue 0 is stopped, it is safe to assume that all
+ * other queues are stopped by driver via
+ * ieee80211_stop_queues() below. This means, there is
+ * no need to stop it again and hence continue
+ */
+ if (ieee80211_queue_stopped(ah->hw, 0)) {
+ wiphy_unlock(ah->hw->wiphy);
+ continue;
+ }
+
ieee80211_stop_queues(ah->hw);
for (j = 0; j < ah->num_radio; j++) {
@@ -1301,6 +1313,8 @@ static void ath12k_core_pre_reconfigure_recovery(struct ath12k_base *ab)
idr_destroy(&ar->txmgmt_idr);
wake_up(&ar->txmgmt_empty_waitq);
}
+
+ wiphy_unlock(ah->hw->wiphy);
}
wake_up(&ab->wmi_ab.tx_credits_wq);
--
2.34.1
