On 7/12/2024 9:11 PM, James Prestwood wrote: > Hi, > > I've seen this error mentioned on random forum posts, but its always associated with a kernel crash/warning or some very obvious negative behavior. I've noticed this occasionally and at one location very frequently during FT roaming, specifically just after CMD_ASSOCIATE is issued. For our company run networks I'm not seeing any negative behavior apart from a 3 second delay in sending the re-association frame since the kernel waits for this timeout. But we have some networks our clients run on that we do not own (different vendor), and we are seeing association timeouts after this error occurs and in some cases the AP is sending a deauthentication with reason code 8 instead of replying with a reassociation reply and an error status, which is quite odd. > > We are chasing down this with the vendor of these APs as well, but the behavior always happens after we see this key removal failure/timeout on the client side. So it would appear there is potentially a problem on both the client and AP. My guess is _something_ about the re-association frame changes when this error is encountered, but I cannot see how that would be the case. We are working to get PCAPs now, but its through a 3rd party, so that timing is out of my control. > > From the kernel code this error would appear innocuous, the old key is failing to be removed but it gets immediately replaced by the new key. And we don't see that addition failing. Am I understanding that logic correctly? I.e. this logic: > > https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/net/mac80211/key.c#n503 > > Below are a few kernel logs of the issue happening, some with the deauth being sent by the AP, some with just timeouts: > > --- No deauth frame sent, just association timeouts after the error --- > > Jul 11 00:05:30 kernel: wlan0: disconnect from AP <previous BSS> for new assoc to <new BSS> > Jul 11 00:05:33 kernel: ath10k_pci 0000:02:00.0: failed to install key for vdev 0 peer <previous BSS>: -110 > Jul 11 00:05:33 kernel: wlan0: failed to remove key (0, <previous BSS>) from hardware (-110) > Jul 11 00:05:33 kernel: wlan0: associate with <new BSS> (try 1/3) > Jul 11 00:05:33 kernel: wlan0: associate with <new BSS> (try 2/3) > Jul 11 00:05:33 kernel: wlan0: associate with <new BSS> (try 3/3) > Jul 11 00:05:33 kernel: wlan0: association with <new BSS> timed out > Jul 11 00:05:36 kernel: wlan0: authenticate with <new BSS> > Jul 11 00:05:36 kernel: wlan0: send auth to <new BSS>a (try 1/3) > Jul 11 00:05:36 kernel: wlan0: authenticated > Jul 11 00:05:36 kernel: wlan0: associate with <new BSS> (try 1/3) > Jul 11 00:05:36 kernel: wlan0: RX AssocResp from <new BSS> (capab=0x1111 status=0 aid=16) > Jul 11 00:05:36 kernel: wlan0: associated > > --- Deauth frame sent amidst the association timeouts --- > > Jul 11 00:43:18 kernel: wlan0: disconnect from AP <previous BSS> for new assoc to <new BSS> > Jul 11 00:43:21 kernel: ath10k_pci 0000:02:00.0: failed to install key for vdev 0 peer <previous BSS>: -110 > Jul 11 00:43:21 kernel: wlan0: failed to remove key (0, <previous BSS>) from hardware (-110) > Jul 11 00:43:21 kernel: wlan0: associate with <new BSS> (try 1/3) > Jul 11 00:43:21 kernel: wlan0: deauthenticated from <new BSS> while associating (Reason: 8=DISASSOC_STA_HAS_LEFT) > Jul 11 00:43:24 kernel: wlan0: authenticate with <new BSS> > Jul 11 00:43:24 kernel: wlan0: send auth to <new BSS> (try 1/3) > Jul 11 00:43:24 kernel: wlan0: authenticated > Jul 11 00:43:24 kernel: wlan0: associate with <new BSS> (try 1/3) > Jul 11 00:43:24 kernel: wlan0: RX AssocResp from <new BSS> (capab=0x1111 status=0 aid=101) > Jul 11 00:43:24 kernel: wlan0: associated > Hi James, this is QCA6174, right? could you also share firmware version? >
