bss_config->key_mgmt specifies the AKM suites that are usable in
hardware. This variable is set to specific values while iterating
over the advertised AKM suites. This means the final value of the
variable depends on the order of the entries in the AKM suites
array. Instead of setting the variable, just set the relevant bits
in the key_mgmt bit field to make us independent of the order of
entries.
This behaviour is derived from the downstream driver that does the
same.
Also, set bss_config->key_mgmt to zero explicitly right before the
loop. bss_config has been zero allocated by the caller already, but
do so again to safe the reader from following the code path.
Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
---
drivers/net/wireless/marvell/mwifiex/uap_cmd.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/marvell/mwifiex/uap_cmd.c b/drivers/net/wireless/marvell/mwifiex/uap_cmd.c
index 7f822660fd955..57280eaae483c 100644
--- a/drivers/net/wireless/marvell/mwifiex/uap_cmd.c
+++ b/drivers/net/wireless/marvell/mwifiex/uap_cmd.c
@@ -52,13 +52,14 @@ int mwifiex_set_secure_params(struct mwifiex_private *priv,
if (params->crypto.wpa_versions & NL80211_WPA_VERSION_2)
bss_config->protocol |= PROTOCOL_WPA2;
+ bss_config->key_mgmt = 0;
for (i = 0; i < params->crypto.n_akm_suites; i++) {
switch (params->crypto.akm_suites[i]) {
case WLAN_AKM_SUITE_8021X:
- bss_config->key_mgmt = KEY_MGMT_EAP;
+ bss_config->key_mgmt |= KEY_MGMT_EAP;
break;
case WLAN_AKM_SUITE_PSK:
- bss_config->key_mgmt = KEY_MGMT_PSK;
+ bss_config->key_mgmt |= KEY_MGMT_PSK;
break;
default:
break;
--
2.39.2
