On 6/10/2024 7:25 PM, Lingbo Kong wrote: > Currently, the calculation of ack signal strength is incorrect. > > This is because before calculating the ack signal strength, ath11k need > to determine whether the hardware and firmware support db2dbm. If the > hardware and firmware support db2dbm, do not need to add noise floor, > otherwise, need to add noise floor. > > Besides, the value of ack_rssi passed by firmware to ath11k should be a > signed number, so change its type to s8. > > After that, "iw wlan0 station dump" show the correct ack signal strength. > > Such as: > root@CDCCSTEX0799733-LIN:~# iw wlp88s0 station dump > Station 00:03:7f:12:df:df (on wlp88s0) > inactive time: 75 ms > rx bytes: 11599 > rx packets: 99 > tx bytes: 9029 > tx packets: 81 > tx retries: 4 > tx failed: 0 > rx drop misc: 2 > signal: -16 dBm > signal avg: -24 dBm > tx bitrate: 1560.0 MBit/s VHT-MCS 9 80MHz VHT-NSS 4 > tx duration: 9230 us > rx bitrate: 1560.0 MBit/s VHT-MCS 9 80MHz VHT-NSS 4 > rx duration: 7201 us > last ack signal:-23 dBm > avg ack signal: -22 dBm > > Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.30 > Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1 > > Signed-off-by: Lingbo Kong <quic_lingbok@xxxxxxxxxxx> Acked-by: Jeff Johnson <quic_jjohnson@xxxxxxxxxxx>
