Search Linux Wireless

Re: [PATCH v4 1/3] wifi: ath12k: report station mode transmit rate

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 2024/4/26 19:21, Kalle Valo wrote:
Lingbo Kong <quic_lingbok@xxxxxxxxxxx> writes:

On 2024/4/26 0:54, Kalle Valo wrote:
Lingbo Kong <quic_lingbok@xxxxxxxxxxx> writes:

+static void ath12k_dp_tx_update_txcompl(struct ath12k *ar, struct
hal_tx_status *ts)
+{
+	struct ath12k_base *ab = ar->ab;
+	struct ath12k_peer *peer;
+	struct ath12k_sta *arsta;
+	struct ieee80211_sta *sta;
+	u16 rate;
+	u8 rate_idx = 0;
+	int ret;
+
+	spin_lock_bh(&ab->base_lock);

Did you analyse how this function, and especially taking the
base_lock,
affects performance?

The base_lock is used here because of the need to look for peers based
on the ts->peer_id when calling ath12k_peer_find_by_id() function,
which i think might affect performance.

Do i need to run a throughput test?

Ok, so to answer my question: no, you didn't do any performance
analysis. Throughput test might not be enough, for example the driver
can be used on slower systems and running the test on a fast CPU might
not reveal any problem. A proper analysis would be much better.


Hi, kalle,
I did a simple performance analysis of the ath12k_dp_tx_update_txcompl() function on slower systems.

Firstly, i use perf tool to set dynamic tracepoints in ath12k_dp_tx_complete_msdu() function, and then used the command of "iperf -c ip address -w 4M -n 1G -i 1" to do traffic test.

During this process, use ./perf record -a -g to detect the performace of the system.

Finally, compare the results with and without this patch.

without this patch
./perf report output
children    self	command		symbol
7.28%	   0.08%      ksoftirqd/0 ath12k_dp_tx_complete_msdu
5.96%      0.03%      swapper     ath12k_dp_tx_complete_msdu   		

iperf output
[  1] 0.0000-62.6712 sec  1.00 GBytes   137 Mbits/sec

with this patch
children    self       command         symbol
7.42%	   0.08%      ksoftirqd/0  ath12k_dp_tx_complete_msdu
6.32%      0.03%      swapper      ath12k_dp_tx_complete_msdu

iperf output
[  1] 0.0000-62.6732 sec  1.00 GBytes   137 Mbits/sec

As can be seen from the table above, with this patch, the CPU time percentage will increase by 0.5%.

So, i think applying this patch will definitely have an impact on system performance, but the impact is not that big and i think it can be ignored:)

Best regards
Lingbo Kong




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux