On 4/24/2024 10:57 PM, Harshitha Prem wrote: > From: Karthikeyan Periyasamy <quic_periyasa@xxxxxxxxxxx> > > Currently, mac allocate/register and core_pdev_create are initiated > immediately when QMI firmware ready event is received for a particular > device. > > With hardware device group abstraction, QMI firmware ready event can be > received simultaneously for different devices in the group and so, it > should not be registered immediately rather it has to be deferred until > all devices in the group has received QMI firmware ready. > > To handle this, refactor the code of core start to move the following > apis inside a wrapper ath12k_core_hw_group_start() > * ath12k_mac_allocate() > * ath12k_core_pdev_create() > * ath12k_core_rfkill_config() > * ath12k_mac_register() > * ath12k_hif_irq_enable() > > similarly, move the corresponding destroy/unregister/disable apis > inside wrapper ath12k_core_hw_group_stop() > > Add the device flags to indicate pdev created and IRQ enabled which would > be helpful for device clean up during failure cases. > > Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1 > > Signed-off-by: Karthikeyan Periyasamy <quic_periyasa@xxxxxxxxxxx> > Co-developed-by: Harshitha Prem <quic_hprem@xxxxxxxxxxx> > Signed-off-by: Harshitha Prem <quic_hprem@xxxxxxxxxxx> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 Acked-by: Jeff Johnson <quic_jjohnson@xxxxxxxxxxx>
