Harshitha Prem <quic_hprem@xxxxxxxxxxx> writes: > To support multi-link operation, multiple devices with different bands say > 2 GHz or 5 GHz or 6 GHz can be combined together as a group and provide > an abstraction to mac80211. > > Device group abstraction - when there are multiple devices that are > connected by any means of communication interface between them, then these > devices can be combined together as a single group using a group id to form > a group abstraction. In ath12k driver, this abstraction would be named as > ath12k_hw_group (ag). > > Please find below illustration of device group abstraction with two > devices. > > Grouping of multiple devices (in future) > +------------------------------------------------------------------------+ > | +-------------------------------------+ +-------------------+ | > | | +-----------+ | | +-----------+ | | +-----------+ | | > | | | ar (2GHz) | | | | ar (5GHz) | | | | ar (6GHz) | | | > | | +-----------+ | | +-----------+ | | +-----------+ | | > | | ath12k_base (ab) | | ath12k_base (ab) | | > | | (Dual band device) | | | | > | +-------------------------------------+ +-------------------+ | > | ath12k_hw_group (ag) based on group id | > +------------------------------------------------------------------------+ > > Say for example, device 1 has two radios (2 GHz and 5 GHz band) and > device 2 has one radio (6 GHz). > > In existing code - > device 1 will have two hardware abstractions hw1 (2 GHz) and hw2 > (5 GHz) will be registered separately to mac80211 as phy0 and phy1 > respectively. Similarly, device 2 will register its hw (6GHz) as > phy2 to mac80211. > > In future, with multi-link abstraction > > combination 1 - Different group id for device1 and device 2 > Device 1 will create a single hardware abstraction hw1 > (2 GHz and 5 GHz) and will be registered to mac80211 as > phy0. similarly, device 2 will register its hardware > (6 GHz) to mac80211 as phy1. > > combination 2 - Same group id for device1 and device 2 > Both device details are combined together as a group, say > group1, with single hardware abstraction of radios 2 GHz, > 5 GHz and 6 GHz band details and will be registered to > mac80211 as phy0. > > Add base infrastructure changes to add device grouping abstraction with > a single device. > > This patch series brings the base code changes with following order: > 1. Refactor existing code which would facilitate in introducing > device group abstraction. > 2. Create a device group abstraction during device probe. > 3. Start the device group only after QMI firmware ready event is > received for all the devices that are combined in the group. > 4. Move the hardware abstractions (ath12k_hw - ah) from device > (ath12k_base - ab) to device group abstraction (ag) as it would > ease in having different combinations of group abstraction that > can be registered to mac80211. > > > Depends-on: > [PATCH 0/3] wifi: ath12k: Refactor the hardware recovery > procedures Are you referring to this patchset: https://patchwork.kernel.org/project/linux-wireless/list/?series=821155&state=*&order=date That was sent three months ago and at least I couldn't find a newer version. So I'll just drop this patchset for now without even looking at it. -- https://patchwork.kernel.org/project/linux-wireless/list/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
