On 3/12/2024 6:55 AM, Rameshkumar Sundaram wrote: > From: Sriram R <quic_srirrama@xxxxxxxxxxx> > > With the introduction of Multi Link Operation (MLO) support in > IEEE802.11be, each EHT AP/non AP interface is capable of > operating with multiple radio links. > > cfg80211/mac80211 expects drivers to abstract the communication > between such Multi Link HW and mac80211/cfg80211 since it depends > on different driver/HW implementation. Hence the single wiphy > abstraction with changes in datastructures were introduced in > "wifi: ath12k: Introduce hw abstraction" > > This patchset extends the implementation to allow combination > of multiple underlying radios into a single composite hw/wiphy > for registration. Since now multiple radios are represented by > a single wiphy, changes are required in various mac ops that the > driver supports since the driver now needs to learn on how to tunnel > various mac ops properly to a specific radio. > > This patchset covers the basic mac80211 ops for an interface bring up > and operation. > > Note: > Monitor and hw reconfig support for Single Wiphy will be done in future > patchsets. > > --- > v4: > - Updated missing Signed-off details for patches. > > v3: > - Rebased on ToT (added additional ar check in PATCH 08/12 for p2p) > - Introduced iterator to loop through ars in an ah(for_each_ar()) > - Addressed comments on reverse xmas tree declaration style. > > v2: > - Rebased on ToT and dependent patchset > > > Karthikeyan Periyasamy (1): > wifi: ath12k: add multiple radio support in a single MAC HW > un/register > > Sriram R (11): > wifi: ath12k: Modify add and remove chanctx ops for single wiphy > support > wifi: ath12k: modify ath12k mac start/stop ops for single wiphy > wifi: ath12k: vdev statemachine changes for single wiphy > wifi: ath12k: scan statemachine changes for single wiphy > wifi: ath12k: fetch correct radio based on vdev status > wifi: ath12k: Cache vdev configs before vdev create > wifi: ath12k: Add additional checks for vif and sta iterators > wifi: ath12k: modify regulatory support for single wiphy architecture > wifi: ath12k: Modify set and get antenna mac ops for single wiphy > wifi: ath12k: Modify rts threshold mac op for single wiphy > wifi: ath12k: support get_survey mac op for single wiphy > > drivers/net/wireless/ath/ath12k/core.h | 38 +- > drivers/net/wireless/ath/ath12k/hw.h | 1 + > drivers/net/wireless/ath/ath12k/mac.c | 911 +++++++++++++++++++------ > drivers/net/wireless/ath/ath12k/p2p.c | 3 +- > drivers/net/wireless/ath/ath12k/p2p.h | 1 + > drivers/net/wireless/ath/ath12k/reg.c | 55 +- > 6 files changed, 785 insertions(+), 224 deletions(-) > ath12k-check reports the following issues when run against the series: drivers/net/wireless/ath/ath12k/core.h:994: Macro argument reuse 'index' - possible side-effects? drivers/net/wireless/ath/ath12k/core.h:994: Macro argument reuse 'ah' - possible side-effects? drivers/net/wireless/ath/ath12k/mac.c:3635: Please don't use multiple blank lines drivers/net/wireless/ath/ath12k/mac.c:6230: line length of 92 exceeds 90 columns drivers/net/wireless/ath/ath12k/mac.c:8429: Missing a blank line after declarations
