As discussed in [1] lets not use WMI_SCAN_XXX defines in combination with scan_flags directly when setting scan params in struct scan_req_params but use the underlying bitfield. This bitfield is then converted to WMI_SCAN_XXX when filling the WMI command to send to the firmware. [1] https://lore.kernel.org/all/871qae51wx.fsf@xxxxxxxxxx/ Tested-on: QCN9074 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1 Signed-off-by: Nicolas Escande <nico.escande@xxxxxxxxx> --- drivers/net/wireless/ath/ath11k/mac.c | 6 +++--- drivers/net/wireless/ath/ath11k/wmi.c | 2 +- 2 files changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c index be04f823566f..7bf5d1068164 100644 --- a/drivers/net/wireless/ath/ath11k/mac.c +++ b/drivers/net/wireless/ath/ath11k/mac.c @@ -4013,7 +4013,7 @@ static int ath11k_mac_op_hw_scan(struct ieee80211_hw *hw, req->ssids[i].ssid_len); } } else { - arg->scan_flags |= WMI_SCAN_FLAG_PASSIVE; + arg->scan_f_passive = 1; } if (req->n_channels) { @@ -9252,8 +9252,8 @@ static int ath11k_mac_op_remain_on_channel(struct ieee80211_hw *hw, arg->dwell_time_active = scan_time_msec; arg->dwell_time_passive = scan_time_msec; arg->max_scan_time = scan_time_msec; - arg->scan_flags |= WMI_SCAN_FLAG_PASSIVE; - arg->scan_flags |= WMI_SCAN_FILTER_PROBE_REQ; + arg->scan_f_passive = 1; + arg->scan_f_filter_prb_req = 1; arg->burst_duration = duration; ret = ath11k_start_scan(ar, arg); diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c index 688ee20528a0..78c11025c21c 100644 --- a/drivers/net/wireless/ath/ath11k/wmi.c +++ b/drivers/net/wireless/ath/ath11k/wmi.c @@ -2098,7 +2098,7 @@ void ath11k_wmi_start_scan_init(struct ath11k *ar, WMI_SCAN_EVENT_BSS_CHANNEL | WMI_SCAN_EVENT_FOREIGN_CHAN | WMI_SCAN_EVENT_DEQUEUED; - arg->scan_flags |= WMI_SCAN_CHAN_STAT_EVENT; + arg->scan_f_chan_stat_evnt = 1; if (test_bit(WMI_TLV_SERVICE_PASSIVE_SCAN_START_TIME_ENHANCE, ar->ab->wmi_ab.svc_map)) -- 2.43.0
