Do not clear the interrupt mask register on MT7915, since that prevents
MCU_CMD interrupts from being reported, thus causing timeouts during the
reset sequence. Defer stopping WED until tx/rx processing activity has
stopped.
Signed-off-by: Felix Fietkau <nbd@xxxxxxxx>
---
drivers/net/wireless/mediatek/mt76/mt7915/mac.c | 9 +++------
1 file changed, 3 insertions(+), 6 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt7915/mac.c b/drivers/net/wireless/mediatek/mt76/mt7915/mac.c
index b01edbed969c..e45361111f9b 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7915/mac.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7915/mac.c
@@ -1520,12 +1520,6 @@ void mt7915_mac_reset_work(struct work_struct *work)
if (!(READ_ONCE(dev->recovery.state) & MT_MCU_CMD_STOP_DMA))
return;
- if (mtk_wed_device_active(&dev->mt76.mmio.wed)) {
- mtk_wed_device_stop(&dev->mt76.mmio.wed);
- if (!is_mt798x(&dev->mt76))
- mt76_wr(dev, MT_INT_WED_MASK_CSR, 0);
- }
-
ieee80211_stop_queues(mt76_hw(dev));
if (ext_phy)
ieee80211_stop_queues(ext_phy->hw);
@@ -1545,6 +1539,9 @@ void mt7915_mac_reset_work(struct work_struct *work)
mutex_lock(&dev->mt76.mutex);
+ if (mtk_wed_device_active(&dev->mt76.mmio.wed))
+ mtk_wed_device_stop(&dev->mt76.mmio.wed);
+
mt76_wr(dev, MT_MCU_INT_EVENT, MT_MCU_INT_EVENT_DMA_STOPPED);
if (mt7915_wait_reset_state(dev, MT_MCU_CMD_RESET_DONE)) {
--
2.43.0
