On Wed, Nov 26, 2008 at 10:21:12AM +0530, Sujith wrote:
> Jouni Malinen wrote:
> > + * @NL80211_ATTR_WIPHY_FREQ: frequency of the selected channel in MHz
> > + * @NL80211_ATTR_WIPHY_SEC_CHAN_OFFSET: included with NL80211_ATTR_WIPHY_FREQ
> > + * if HT40 (40 MHz channels) are allowed:
> > + * NL80211_SEC_CHAN_BELOW = secondary channel is below the primary channel
> > + * NL80211_SEC_CHAN_ABOVE = secondary channel is above the primary channel
>
> The driver needs to know if the selected channel is HT or not.
> It receives only HT20/HT40+/HT40- flags, but a HT/non-HT flag is required too.
Yes, indeed. I added a new enum value for that:
NL82011_SEC_CHAN_NO_HT = no HT (this is the default if
NL80211_ATTR_WIPHY_SEC_CHAN_OFFSET is not included)
NL80211_SEC_CHAN_DISABLED = HT20 only
NL80211_SEC_CHAN_BELOW = HT40-
NL80211_SEC_CHAN_ABOVE = HT40+
The driver will then get hw.conf.ht.{enabled,sec_chan_offset} with the
needed information.
--
Jouni Malinen PGP id EFC895FA
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
