In current code, the management frames must be sent after vdev is started.
But for P2P device, vdev won't start until P2P negotiation is done. So
this logic doesn't make sense for P2P device.
Also use ar->conf_mutex to synchronize vdev delete and mgmt, TX.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
Signed-off-by: Kang Yang <quic_kangyang@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath12k/mac.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/ath/ath12k/mac.c b/drivers/net/wireless/ath/ath12k/mac.c
index a77fb786bc0a..6632d5266c1a 100644
--- a/drivers/net/wireless/ath/ath12k/mac.c
+++ b/drivers/net/wireless/ath/ath12k/mac.c
@@ -4995,8 +4995,8 @@ static void ath12k_mgmt_over_wmi_tx_work(struct work_struct *work)
}
arvif = ath12k_vif_to_arvif(skb_cb->vif);
- if (ar->allocated_vdev_map & (1LL << arvif->vdev_id) &&
- arvif->is_started) {
+ mutex_lock(&ar->conf_mutex);
+ if (ar->allocated_vdev_map & (1LL << arvif->vdev_id)) {
ret = ath12k_mac_mgmt_tx_wmi(ar, arvif, skb);
if (ret) {
ath12k_warn(ar->ab, "failed to tx mgmt frame, vdev_id %d :%d\n",
@@ -5010,6 +5010,7 @@ static void ath12k_mgmt_over_wmi_tx_work(struct work_struct *work)
arvif->is_started);
ath12k_mgmt_over_wmi_tx_drop(ar, skb);
}
+ mutex_unlock(&ar->conf_mutex);
}
}
--
2.34.1
