eSR is activated when a chanctx is assigned to more than one link.
During eSR activation we should disable RLC for both phys, and configure
the FW with a special phy command for both phys.
Currently we assign the phy_ctxt to the link only after eSR activation,
so RLC is not disabled for the new phy_ctxt, and a cmd is not sent to FW.
Fix this by first assigning the new phy_ctxt to the link and then
doing the eSR activation.
Fixes: 12bacfc2c065 ("wifi: iwlwifi: handle eSR transitions")
Reviewed-by: Gregory Greenman <gregory.greenman@xxxxxxxxx>
Signed-off-by: Miri Korenblit <miriam.rachel.korenblit@xxxxxxxxx>
---
drivers/net/wireless/intel/iwlwifi/mvm/mld-mac80211.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/mld-mac80211.c b/drivers/net/wireless/intel/iwlwifi/mvm/mld-mac80211.c
index 8e263acbc763..61170173f917 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/mld-mac80211.c
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/mld-mac80211.c
@@ -271,17 +271,17 @@ __iwl_mvm_mld_assign_vif_chanctx(struct iwl_mvm *mvm,
}
}
+ mvmvif->link[link_id]->phy_ctxt = phy_ctxt;
+
if (iwl_mvm_is_esr_supported(mvm->fwrt.trans) && n_active > 1) {
mvmvif->link[link_id]->listen_lmac = true;
ret = iwl_mvm_esr_mode_active(mvm, vif);
if (ret) {
IWL_ERR(mvm, "failed to activate ESR mode (%d)\n", ret);
- return ret;
+ goto out;
}
}
- mvmvif->link[link_id]->phy_ctxt = phy_ctxt;
-
if (switching_chanctx) {
/* reactivate if we turned this off during channel switch */
if (vif->type == NL80211_IFTYPE_AP)
--
2.34.1
