Kang Yang <quic_kangyang@xxxxxxxxxxx> wrote: > For AP mode, the peer is created earlier in ath12k_mac_op_add_interface() but > ath12k_mac_op_assign_vif_chanctx() will try to create peer again. Then an > error will return which makes AP mode startup fail. > > Kernel log: > > [ 5017.665006] ath12k_pci 0000:04:00.0: failed to create peer after vdev start delay: -22 > > wpa_supplicant log: > > Failed to set beacon parameters > Interface initialization failed > wls1: interface state UNINITIALIZED->DISABLED > wls1: AP-DISABLED > wls1: Unable to setup interface. > Failed to initialize AP interface > wls1: interface state DISABLED->DISABLED > wls1: AP-DISABLED > > So fix this check and enable AP mode for WCN7850, as now AP mode works normally. > > Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4 > > Signed-off-by: Kang Yang <quic_kangyang@xxxxxxxxxxx> > Acked-by: Jeff Johnson <quic_jjohnson@xxxxxxxxxxx> > Signed-off-by: Kalle Valo <quic_kvalo@xxxxxxxxxxx> Patch applied to ath-next branch of ath.git, thanks. ed7e818a7b50 wifi: ath12k: fix and enable AP mode for WCN7850 -- https://patchwork.kernel.org/project/linux-wireless/patch/20231121022459.17209-1-quic_kangyang@xxxxxxxxxxx/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
