Hi Kalle,
On 11/29/23 03:59, Kalle Valo wrote:
James Prestwood <prestwoj@xxxxxxxxx> wrote:
Broadcast action frames are needed for the Device Provisioning
Protocol (DPP) for Presence and PKEX Exchange requests. Currently
just ath9k has this capability so this is being enabled for
ath10k (for at least one hardware variant).
Add a new capability flag in ath10k_hw_params to indicate support
for receiving multicast action frames. This bit is then checked
when configuring the RX filter and (if set) multicast action frame
registration is enabled.
Until more hardware can be tested only the "qca6174 hw3.2" variant
is enabling this feature.
Note: I went ahead and removed the 'changed_flags' mask operation
since it had no effect, that parameter was not being used anywhere.
Tested-on: QCA6174 hw3.2 WLAN.RM.4.4.1-00288-
Signed-off-by: James Prestwood <prestwoj@xxxxxxxxx>
Signed-off-by: Kalle Valo <quic_kvalo@xxxxxxxxxxx>
This had a simple conflict in ath10k_configure_filter() and I fixed it in the
pending branch, please check:
https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=pending&id=cc9f5dfd74f93ae6f596bccc3a5b92fe3f18c439
In the future please use ath.git master branch as the baseline for ath driver patches.
Thank you for resolving that, and I'll use ath.git in the future.
Thanks,
James
