There is a layout mismatch between the bitfield representing scan_flags in
struct ath12k_wmi_scan_req_arg & the bits as defined in the WMI_SCAN_XXX
macros. Fix it by making the biefield match de #define values.
I especialy checked by adding WMI_SCAN_FLAG_FORCE_ACTIVE_ON_DFS to
scan_flags and the firmware started to unconditionnaly send probe request
on DFS channels during scan.
Tested-on: QCN9274 hw2.0 PCI CI_WLAN.WBE.1.2.1-00148.1-QCAHKSWPL_SILICONZ-7
Signed-off-by: Nicolas Escande <nico.escande@xxxxxxxxx>
---
drivers/net/wireless/ath/ath12k/wmi.h | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/net/wireless/ath/ath12k/wmi.h b/drivers/net/wireless/ath/ath12k/wmi.h
index 629373d67421..2b5b46f8898e 100644
--- a/drivers/net/wireless/ath/ath12k/wmi.h
+++ b/drivers/net/wireless/ath/ath12k/wmi.h
@@ -3307,17 +3307,17 @@ struct ath12k_wmi_scan_req_arg {
scan_f_filter_prb_req:1,
scan_f_bypass_dfs_chn:1,
scan_f_continue_on_err:1,
+ scan_f_promisc_mode:1,
+ scan_f_force_active_dfs_chn:1,
+ scan_f_add_tpc_ie_in_probe:1,
+ scan_f_add_ds_ie_in_probe:1,
+ scan_f_add_spoofed_mac_in_probe:1,
scan_f_offchan_mgmt_tx:1,
scan_f_offchan_data_tx:1,
- scan_f_promisc_mode:1,
scan_f_capture_phy_err:1,
scan_f_strict_passive_pch:1,
scan_f_half_rate:1,
scan_f_quarter_rate:1,
- scan_f_force_active_dfs_chn:1,
- scan_f_add_tpc_ie_in_probe:1,
- scan_f_add_ds_ie_in_probe:1,
- scan_f_add_spoofed_mac_in_probe:1,
scan_f_add_rand_seq_in_probe:1,
scan_f_en_ie_whitelist_in_probe:1,
scan_f_forced:1,
--
2.43.0
