Search Linux Wireless

Re: [PATCH 1/7] wifi: ath12k: get msi_data again after request_irq is called

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 11/20/2023 2:15 AM, Kang Yang wrote:
> The reservation mode of interrupts in kernel assigns a dummy vector
> when the interrupt is allocated and assigns a real vector when the
> request_irq is called. The reservation mode helps to ease vector
> pressure when devices with a large amount of queues/interrupts are
> initialized, but only a minimal subset of those queues/interrupts
> is actually used.
> 
> So on reservation mode, the msi_data may change after request_irq is
> called, then it will lead to spurious interrupt. But when VT-d in
> BIOS is enabled and ath12k can get 32 MSI vectors, ath12k always get
> the same msi_data before and after request_irq.
> 
> So in case of one MSI vector, ath12k need read msi_data again after
> request_irq is called, and then the correct msi_data is programmed
> into WCN7850 hardware components.
> 
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4
> 
> Signed-off-by: Kang Yang <quic_kangyang@xxxxxxxxxxx>
Acked-by: Jeff Johnson <quic_jjohnson@xxxxxxxxxxx>




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux