On Fri, Nov 21, 2008 at 11:45:18PM +0200, Maxim Levitsky wrote: >> I double check that I use right kernel (install it again). > > compiled kernel again, and installed it, same results. Can you confirm that the proper mac address shows up if you do ifconfig or macchanger -s? I think it's just not associating. Also can you try specifying the ap again to trigger a probe after ifconfig up: $ iwconfig wlan0 ap <your AP's mac address> Though I did forget about this gem, try this too: diff --git a/drivers/net/wireless/ath5k/pcu.c b/drivers/net/wireless/ath5k/pcu.c index d7f0c10..f401691 100644 --- a/drivers/net/wireless/ath5k/pcu.c +++ b/drivers/net/wireless/ath5k/pcu.c @@ -267,24 +267,23 @@ void ath5k_hw_get_lladdr(struct ath5k_hw *ah, u8 *mac) * @mac: The card's mac address * * Set station id on hw using the provided mac address - * - * NOTE: This is only called during attach, don't call it - * on reset because it overwrites all AR5K_STA_ID1 settings. - * We have set_opmode (above) for reset. */ int ath5k_hw_set_lladdr(struct ath5k_hw *ah, const u8 *mac) { u32 low_id, high_id; + u32 pcu_reg; ATH5K_TRACE(ah->ah_sc); /* Set new station ID */ memcpy(ah->ah_sta_id, mac, ETH_ALEN); + pcu_reg = ath5k_hw_reg_read(ah, AR5K_STA_ID1) & 0xffff0000; + low_id = AR5K_LOW_ID(mac); high_id = AR5K_HIGH_ID(mac); ath5k_hw_reg_write(ah, low_id, AR5K_STA_ID0); - ath5k_hw_reg_write(ah, high_id, AR5K_STA_ID1); + ath5k_hw_reg_write(ah, pcu_reg | high_id, AR5K_STA_ID1); return 0; } -- Bob Copeland %% www.bobcopeland.com -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html