From: Seevalamuthu Mariappan <quic_seevalam@xxxxxxxxxxx>
In some race conditions, calibration done QMI message is received even
before host wait starts for calibration to be done.
Due to this, resetting firmware was not performed after calibration.
Hence, remove cal_done check in ath11k_qmi_fwreset_from_cold_boot()
as this is called only from probe.
Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
Signed-off-by: Seevalamuthu Mariappan <quic_seevalam@xxxxxxxxxxx>
Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath11k/qmi.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath11k/qmi.c b/drivers/net/wireless/ath/ath11k/qmi.c
index c4eab5d7f..617abb441 100644
--- a/drivers/net/wireless/ath/ath11k/qmi.c
+++ b/drivers/net/wireless/ath/ath11k/qmi.c
@@ -2844,7 +2844,7 @@ int ath11k_qmi_fwreset_from_cold_boot(struct ath11k_base *ab)
{
int timeout;
- if (!ath11k_core_coldboot_cal_support(ab) || ab->qmi.cal_done ||
+ if (!ath11k_core_coldboot_cal_support(ab) ||
ab->hw_params.cbcal_restart_fw == 0)
return 0;
--
2.17.1
