On 3/7/23 03:22, Deren Wu wrote:
From: Neil Chen <yn.chen@xxxxxxxxxxxx>
FIF_* flags from mac80211 is not ABI. mt7921 should not pass it into mcu
directly. Remap FIF_* to driver defined flags as mcu command input.
Fixes: c222f77fd421 ("wifi: mt76: mt7921: fix rx filter incorrect by drv/fw inconsistent")
Signed-off-by: Neil Chen <yn.chen@xxxxxxxxxxxx> > Signed-off-by: Deren Wu <deren.wu@xxxxxxxxxxxx>
I tried this plus the patch it is fixing on 6.2.2+ kernel with 7922 radios,
and behaviour seems worse than before the two patches were applied.
Original problem I was trying to fix is that my STAs will connect fine on 5Ghz,
but then when I try to move them to 2.4Ghz, most will not scan anything.
Packet sniff shows probe responses and requests, so I suspected firmware is
filtering when it should not.
With the two patches applied, even 5Ghz is showing failure, with lots of
beacon loss messages (I am disabling beacon filtering, which previously worked
fine on 7921 nic in 5.19 kernel).
Are there other patches that I should consider to get 7922 to work better in 6.2.2+
kernel?
[root@ct523c-3b7f ~]# cat /debug/ieee80211/wiphy0/mt76/version
chipset: 7922
ASIC-Revision: 0x79220010
hw_sw_ver: 0x8a108a10
build_date: 20221227123154a
bus: 0000:04:00.0
fwcfg: fwcfg-mmio-0000:04:00.0.txt
WM-hw_sw_ver: ____000000
WM-build_date: 20221227123243
WA-hw_sw_ver:
WA-build_date:
Thanks,
Ben
--
Ben Greear <greearb@xxxxxxxxxxxxxxx>
Candela Technologies Inc http://www.candelatech.com
