# iwconfig wlan0 essid "MiddleEarth" key s:XXXXXXXXX
Error for wireless request "Set Encode" (8B2A) :
SET failed on device wlan0 ; Invalid argument.
# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
sit0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11abgn ESSID:"MiddleEarth"
Mode:Managed Frequency:2.442 GHz Access Point: Not-Associated
Tx-Power=15 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:3266-C437-9DA2-5422-18C3-2621-22BB-35D1-B24C-7E80-E99E-9850-AC21-4F8F-7779-18E3 [2] Security mode:open
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Not-associated. What this error means?
Error for wireless request "Set Encode" (8B2A) :
SET failed on device wlan0 ; Invalid argument.
----- Message d'origine ----
De : Luis R. Rodriguez <mcgrof@xxxxxxxxx>
À : Julien HENRY <henryju@xxxxxxxx>
Cc : linux-wireless@xxxxxxxxxxxxxxx
Envoyé le : Samedi, 1 Novembre 2008, 23h16mn 12s
Objet : Re: Re : Re : Not associated with Intel 4965
On Sat, Nov 1, 2008 at 3:00 PM, Julien HENRY <henryju@xxxxxxxx> wrote:
> OK, now I can load the module... but nothing better concerning association.
>
> Nov 1 22:39:24 Capgemini kernel: cfg80211: Using static regulatory domain info
> Nov 1 22:39:24 Capgemini kernel: cfg80211: Regulatory domain: JP
> Nov 1 22:39:24 Capgemini kernel: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
> Nov 1 22:39:24 Capgemini kernel: (2402000 KHz - 2494000 KHz @ 40000 KHz), (600 mBi, 2000 mBm)
> Nov 1 22:39:24 Capgemini kernel: (5160000 KHz - 5250000 KHz @ 40000 KHz), (600 mBi, 2000 mBm)
> Nov 1 22:39:24 Capgemini kernel: (5250000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2000 mBm)
> Nov 1 22:39:24 Capgemini kernel: cfg80211: Calling CRDA for country: JP
> Nov 1 22:39:24 Capgemini kernel: iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27ks
> Nov 1 22:39:24 Capgemini kernel: iwlagn: Copyright(c) 2003-2008 Intel Corporation
> Nov 1 22:39:24 Capgemini kernel: iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
> Nov 1 22:39:24 Capgemini kernel: iwlagn: Detected Intel Wireless WiFi Link 4965AGN REV=0x4
> Nov 1 22:39:24 Capgemini kernel: iwlagn: Tunable channels: 13 802.11bg, 19 802.11a channels
> ...
> Nov 1 22:39:41 Capgemini kernel: iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
> Nov 1 22:39:41 Capgemini kernel: firmware: requesting iwlwifi-4965-2.ucode
> Nov 1 22:39:41 Capgemini kernel: Registered led device: iwl-phy0:radio
> Nov 1 22:39:41 Capgemini kernel: Registered led device: iwl-phy0:assoc
> Nov 1 22:39:41 Capgemini kernel: Registered led device: iwl-phy0:RX
> Nov 1 22:39:41 Capgemini kernel: Registered led device: iwl-phy0:TX
> Nov 1 22:39:41 Capgemini kernel: ADDRCONF(NETDEV_UP): wlan0: link is not ready
> Nov 1 22:39:41 Capgemini kernel: iwlagn: TX Power requested while scanning!
> Nov 1 22:39:41 Capgemini kernel: iwlagn: Error sending TX power (-11)
>
> ...
> Nov 1 22:39:47 Capgemini kernel: iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
> Nov 1 22:39:47 Capgemini kernel: Registered led device: iwl-phy0:radio
> Nov 1 22:39:47 Capgemini kernel: Registered led device: iwl-phy0:assoc
> Nov 1 22:39:47 Capgemini kernel: Registered led device: iwl-phy0:RX
> Nov 1 22:39:47 Capgemini kernel: Registered led device: iwl-phy0:TX
> Nov 1 22:39:47 Capgemini kernel: ADDRCONF(NETDEV_UP): wlan0: link is not ready
>
> Anything I can try?
Looks good to me. Try the usual commands/applications to connect to an
AP. I'm not going to help you with that.
Luis
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
