Macros prefixed with CONFIG_ are intended to be defined only by Kconfig scripts. Here we remove the prefix from the CONFIG_AUTO_READ_MODE define to avoid confusion when reading the code. This causes no change to functionality. Signed-off-by: Peter Lafreniere <peter@xxxxxxxx> --- v1 -> v2: - Use AUTO_READ_MODE instead of CONFIGURE_AUTO_READ_MODE - Remove netdev from cc list drivers/net/wireless/rsi/rsi_91x_hal.c | 4 ++-- drivers/net/wireless/rsi/rsi_hal.h | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/net/wireless/rsi/rsi_91x_hal.c b/drivers/net/wireless/rsi/rsi_91x_hal.c index c7460fbba014..d4489b943873 100644 --- a/drivers/net/wireless/rsi/rsi_91x_hal.c +++ b/drivers/net/wireless/rsi/rsi_91x_hal.c @@ -894,7 +894,7 @@ static int rsi_load_9113_firmware(struct rsi_hw *adapter) struct ta_metadata *metadata_p; int status; - status = bl_cmd(adapter, CONFIG_AUTO_READ_MODE, CMD_PASS, + status = bl_cmd(adapter, AUTO_READ_MODE, CMD_PASS, "AUTO_READ_CMD"); if (status < 0) return status; @@ -984,7 +984,7 @@ static int rsi_load_9113_firmware(struct rsi_hw *adapter) } rsi_dbg(ERR_ZONE, "Firmware upgrade failed\n"); - status = bl_cmd(adapter, CONFIG_AUTO_READ_MODE, CMD_PASS, + status = bl_cmd(adapter, AUTO_READ_MODE, CMD_PASS, "AUTO_READ_MODE"); if (status) goto fail; diff --git a/drivers/net/wireless/rsi/rsi_hal.h b/drivers/net/wireless/rsi/rsi_hal.h index 5b07262a9740..479b1b0b57a6 100644 --- a/drivers/net/wireless/rsi/rsi_hal.h +++ b/drivers/net/wireless/rsi/rsi_hal.h @@ -69,7 +69,7 @@ #define EOF_REACHED 'E' #define CHECK_CRC 'K' #define POLLING_MODE 'P' -#define CONFIG_AUTO_READ_MODE 'R' +#define AUTO_READ_MODE 'R' #define JUMP_TO_ZERO_PC 'J' #define FW_LOADING_SUCCESSFUL 'S' #define LOADING_INITIATED '1' -- 2.39.0
