The TSF is already reset properly via mac80211's callback. Resetting it in config_interface() is not needed. Signed-off-by: Sujith <Sujith.Manoharan@xxxxxxxxxxx> --- drivers/net/wireless/ath9k/main.c | 11 ----------- 1 files changed, 0 insertions(+), 11 deletions(-) diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c index b349e91..d2b53b5 100644 --- a/drivers/net/wireless/ath9k/main.c +++ b/drivers/net/wireless/ath9k/main.c @@ -1239,17 +1239,6 @@ static int ath9k_config_interface(struct ieee80211_hw *hw, /* Set aggregation protection mode parameters */ sc->sc_config.ath_aggr_prot = 0; - /* - * Reset our TSF so that its value is lower than the - * beacon that we are trying to catch. - * Only then hw will update its TSF register with the - * new beacon. Reset the TSF before setting the BSSID - * to avoid allowing in any frames that would update - * our TSF only to have us clear it - * immediately thereafter. - */ - ath9k_hw_reset_tsf(sc->sc_ah); - /* Disable BMISS interrupt when we're not associated */ ath9k_hw_set_interrupts(sc->sc_ah, sc->sc_imask & -- 1.6.0.3 -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
