On 11/8/2022 5:38 AM, Xiu Jianfeng wrote:
When ath10k_ahb_init() fails, it does not unregister ath10k_pci_driver,
which will cause a resource leak issue, call pci_unregister_driver() in
the error path to fix this issue.
Fixes: 0b523ced9a3c ("ath10k: add basic skeleton to support ahb")
Signed-off-by: Xiu Jianfeng <xiujianfeng@xxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/pci.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
index e56c6a6b1379..22f8f8b20762 100644
--- a/drivers/net/wireless/ath/ath10k/pci.c
+++ b/drivers/net/wireless/ath/ath10k/pci.c
@@ -3800,8 +3800,10 @@ static int __init ath10k_pci_init(void)
ret);
ret = ath10k_ahb_init();
- if (ret)
+ if (ret) {
printk(KERN_ERR "ahb init failed: %d\n", ret);
+ pci_unregister_driver(&ath10k_pci_driver);
+ }
return ret;
}
imo neither the existing code nor the modified code is correct.
the driver is attempting to register to support two different buses.
if either of these is successful then ath10k_pci_init() should return 0
so that hardware attached to the successful bus can be probed and supported.
only if both of these are unsuccessful should ath10k_pci_init() return
an errno.
so I suggest
int ret1, ret2;
ret1 = pci_register_driver(&ath10k_pci_driver);
if (ret1)
printk(KERN_ERR "failed to register ath10k pci driver: %d\n",
ret1);
ret2 = ath10k_ahb_init();
if (ret2)
printk(KERN_ERR "ahb init failed: %d\n", ret2);
if (ret1 && ret2)
return ret1;
/* registered to at least one bus */
return 0;
}
