Wen Gong <quic_wgong@xxxxxxxxxxx> wrote:
> For 11d scan, commit 9dcf6808b253 ("ath11k: add 11d scan offload support")
> increased the timeout from one second to max 10 seconds when 11d scan
> offload enabled and 6 GHz enabled, it is reasonable for the commit, it
> is because the first 11d scan request is sent to firmware before the
> first hw scan request after wlan load, then the hw scan started event
> will reported from firmware after the 11d scan finished, it needs about
> 6 seconds when 6 GHz enabled, so increased it from one second to 10
> seconds in the commit to avoid timed out for hw scan started. Then
> another commit 1f682dc9fb37 ("ath11k: reduce the wait time of 11d scan
> and hw scan while add interface") change the sequence of the first 11d
> scan and hw scan, then ath11k will receive the hw scan started event
> from firmware immediately for the first hw scan, thus ath11k does not
> need set the timeout value to max 10 seconds again, and this is to set
> the timeout value back from 10 seconds to 1 second.
>
> Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3
>
> Signed-off-by: Wen Gong <quic_wgong@xxxxxxxxxxx>
With this patch I started seeing new errors:
[ 1194.815104] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
[ 1196.864157] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
[ 1198.911926] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
This seems to happen after my suspend tests, but didn't have time to
investigate further.
--
https://patchwork.kernel.org/project/linux-wireless/patch/20220919024121.24820-1-quic_wgong@xxxxxxxxxxx/
https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
