From: Chih-Kang Chang <gary.chang@xxxxxxxxxxx> Mac80211 core may ask driver to change to idle mode during HW scan, then H2C command for HW scan will send failed since chip is in idle mode. Therefore, We check the SCANNING flag before entering IPS to prevent this behavior. Signed-off-by: Chih-Kang Chang <gary.chang@xxxxxxxxxxx> Signed-off-by: Ping-Ke Shih <pkshih@xxxxxxxxxxx> --- drivers/net/wireless/realtek/rtw88/mac80211.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/realtek/rtw88/mac80211.c b/drivers/net/wireless/realtek/rtw88/mac80211.c index ef60041fe6bf6..07578ccc4bab3 100644 --- a/drivers/net/wireless/realtek/rtw88/mac80211.c +++ b/drivers/net/wireless/realtek/rtw88/mac80211.c @@ -101,7 +101,8 @@ static int rtw_ops_config(struct ieee80211_hw *hw, u32 changed) rtw_set_channel(rtwdev); if ((changed & IEEE80211_CONF_CHANGE_IDLE) && - (hw->conf.flags & IEEE80211_CONF_IDLE)) + (hw->conf.flags & IEEE80211_CONF_IDLE) && + !test_bit(RTW_FLAG_SCANNING, rtwdev->flags)) rtw_enter_ips(rtwdev); out: -- 2.25.1
