Manikanta Pubbisetty <quic_mpubbise@xxxxxxxxxxx> writes: > On 3/28/2022 11:39 AM, Manikanta Pubbisetty wrote: >> WCN6750 is non-DBS 2x2 11AX chipset. Unlike QCA6390/WCN6855 which >> are DBS (dual band simultaneous) solutions (2 LMACs), WCN6750 has a >> single LMAC supporting 2G, 5G and 6G bands. It can be operated only >> on one band at any given point. >> >> WCN6750 is a PCIe device. Unlike other supported ATH11K PCIe devices >> which are directly attached to APSS (Application Processor SubSystem), >> WCN6750 is not attached to APSS, it is attached to the WPSS >> (Wireless Processor SubSystem) Q6 processor, the FW which runs on the >> Q6 processor will enumerate the PCIe device. Since APSS is unaware of >> such a device, it has to be registered as a platform device(AHB) to the >> kernel for device probing. Like other AHB devices, remoteproc APIs are >> used to boot up or shutdown of WCN6750. >> >> WCN6750 uses both AHB and PCIe ATH11K APIs for it's operation. >> It uses AHB APIs for device probe and booting of the remote processor. >> Once device is booted up, it uses ATH11K PCIe APIs for initialization >> and register access. Hence, it is referred as hybrid bus device in >> the rest of this series. >> >> Since the chip is enumerated by WPSS Q6, device information like >> BAR and BAR size is not known to the APSS processor. A new QMI message >> called device info QMI request will be sent to the target for fetching >> these details. >> >> STA and AP modes are supported; Basic connectivity and ping are >> verified in both the modes. >> >> An important point to note is that though WCN6750 is a PCIe device, >> it cannot be attached to any other platform except on Qualcomm >> Snapdragon SoCs due to the aforementioned reasons. >> >> Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00573-QCAMSLSWPLZ-1 >> Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1 >> Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.5.0.1-01100-QCAHKSWPL_SILICONZ-1 >> Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.4.0.1-00192-QCAHKSWPL_SILICONZ-1 >> >> Manikanta Pubbisetty (12): >> dt: bindings: net: add bindings of WCN6750 for ath11k >> ath11k: Add HW params for WCN6750 >> ath11k: Add bus params for WCN6750 >> ath11k: Add register access logic for WCN6750 >> ath11k: Fetch device information via QMI for WCN6750 >> ath11k: Add QMI changes for WCN6750 >> ath11k: HAL changes to support WCN6750 >> ath11k: Datapath changes to support WCN6750 >> ath11k: Do not put HW in DBS mode for WCN6750 >> ath11k: WMI changes to support WCN6750 >> ath11k: Update WBM idle ring HP after FW mode on >> ath11k: Add support for WCN6750 device >> --- >> Note: >> * Remoteproc driver changes for WCN6750 which takes care of >> downloading the FW and booting of Q6 processor are under >> upstream review. >> Link: https://patchwork.kernel.org/project/linux-remoteproc/cover/1643712724-12436-1-git-send-email-quic_mpubbise@xxxxxxxxxxx/ > > Hi Kalle, > > It looks like the remoteproc changes have landed in linux-next tree. > Shall I remove this dependency and resend the series? Please wait, I want to look at the patchset first and provide comments. -- https://patchwork.kernel.org/project/linux-wireless/list/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
