The existing PCI and MAC codes are only used by 8852AE, so many settings are
put in single function. To be clear, move the settings into an individual
function according to its functionality. Since functions will be shared
with chips, add attributes to make it possible to use common functions.
Also, update the settings to the latest version of our internal code.
This patchset is based on
"rtw89: add firmware reset and dump firmware memory and backtrace" and
"rtw89: update TX power table and 6G, refine IGI, and add TX/RX descriptors V1"
But no actual function dependency.
Chia-Yuan Li (1):
rtw89: pci: refine pci pre_init function
Ping-Ke Shih (15):
rtw89: pci: add register definition to rtw89_pci_info to generalize
pci code
rtw89: pci: add pci attributes to configure operating mode
rtw89: pci: add LTR setting for v1 chip
rtw89: pci: set address info registers depends on chips
rtw89: pci: add deglitch setting
rtw89: pci: add L1 settings
rtw89: extend dmac_pre_init to support 8852C
rtw89: update STA scheduler parameters for v1 chip
rtw89: add chip_ops::{enable,disable}_bb_rf to support v1 chip
rtw89: Turn on CR protection of CMAC
rtw89: 8852c: update security engine setting
rtw89: update scheduler setting
rtw89: initialize NAV control
rtw89: update TMAC parameters
rtw89: update ptcl_init
drivers/net/wireless/realtek/rtw89/core.c | 7 +-
drivers/net/wireless/realtek/rtw89/core.h | 2 +
drivers/net/wireless/realtek/rtw89/mac.c | 129 ++++-
drivers/net/wireless/realtek/rtw89/mac.h | 19 +-
drivers/net/wireless/realtek/rtw89/pci.c | 519 +++++++++++++++---
drivers/net/wireless/realtek/rtw89/pci.h | 211 +++++++
drivers/net/wireless/realtek/rtw89/reg.h | 187 +++++++
drivers/net/wireless/realtek/rtw89/rtw8852a.c | 2 +
.../net/wireless/realtek/rtw89/rtw8852ae.c | 30 +
drivers/net/wireless/realtek/rtw89/rtw8852c.c | 45 ++
.../net/wireless/realtek/rtw89/rtw8852ce.c | 30 +
11 files changed, 1080 insertions(+), 101 deletions(-)
--
2.25.1
