On Tuesday 14 October 2008 02:00:39 Pavel Roskin wrote: > On Mon, 2008-10-13 at 19:36 -0400, Pavel Roskin wrote: > > > p54_config() calls p54_set_freq(), which can fail with -EINVAL. I'm > > looking why it can happen. > > The calibration table only has frequencies in the 2.4GHz band, but the > scan goes through the 5GHz band as well. That's how it fails: > > freq = 5825 > i = 0, priv->iq_autocal[i].freq = 2412 > i = 1, priv->iq_autocal[i].freq = 2417 > i = 2, priv->iq_autocal[i].freq = 2422 > i = 3, priv->iq_autocal[i].freq = 2427 > i = 4, priv->iq_autocal[i].freq = 2432 > i = 5, priv->iq_autocal[i].freq = 2437 > i = 6, priv->iq_autocal[i].freq = 2442 > i = 7, priv->iq_autocal[i].freq = 2447 > i = 8, priv->iq_autocal[i].freq = 2452 > i = 9, priv->iq_autocal[i].freq = 2457 > i = 10, priv->iq_autocal[i].freq = 2462 > i = 11, priv->iq_autocal[i].freq = 2467 > i = 12, priv->iq_autocal[i].freq = 2472 > i = 13, priv->iq_autocal[i].freq = 2484 > phy9: frequency change failed > ret = -22 > > Either we should be using a different table for the 5GHz band, or the > driver should not announce 5GHz channels if the calibration table lacks > them. I ask again: What Card/MAC & RF-Chip do you have? Indigo/Duette/Firsbee or XBow? see switch instruction in p54common.c line 430 in p54_parse_eeprom Regards, Chr -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html