Update the BCMA's chipcommon nand flash driver to detect which
chip-select is used and pass that information via platform data to the
brcmnand driver. Make sure that the brcmnand platform data structure is
always at the beginning of the platform data of the "nflash" device
created by BCMA to allow brcmnand to safely de-reference it.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
MAINTAINERS | 1 +
drivers/bcma/driver_chipcommon_nflash.c | 20 +++++++++++++++++++-
include/linux/bcma/bcma_driver_chipcommon.h | 5 +++++
include/linux/platform_data/brcmnand.h | 12 ++++++++++++
4 files changed, 37 insertions(+), 1 deletion(-)
create mode 100644 include/linux/platform_data/brcmnand.h
diff --git a/MAINTAINERS b/MAINTAINERS
index dd36acc87ce6..404f3eb8ff18 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -3966,6 +3966,7 @@ L: linux-mtd@xxxxxxxxxxxxxxxxxxx
L: bcm-kernel-feedback-list@xxxxxxxxxxxx
S: Maintained
F: drivers/mtd/nand/raw/brcmnand/
+F: include/linux/platform_data/brcmnand.h
BROADCOM STB PCIE DRIVER
M: Jim Quinlan <jim2101024@xxxxxxxxx>
diff --git a/drivers/bcma/driver_chipcommon_nflash.c b/drivers/bcma/driver_chipcommon_nflash.c
index d4f699aef8c4..a1a814750b4a 100644
--- a/drivers/bcma/driver_chipcommon_nflash.c
+++ b/drivers/bcma/driver_chipcommon_nflash.c
@@ -7,18 +7,28 @@
#include "bcma_private.h"
+#include <linux/bitops.h>
#include <linux/platform_device.h>
+#include <linux/platform_data/brcmnand.h>
#include <linux/bcma/bcma.h>
+/* Alternate NAND controller driver name in order to allow both bcm47xxnflash
+ * and bcma_brcmnand to be built into the same kernel image.
+ */
+static const char *bcma_nflash_alt_name = "bcma_brcmnand";
+
struct platform_device bcma_nflash_dev = {
.name = "bcma_nflash",
.num_resources = 0,
};
+static const char *probes[] = { "bcm47xxpart", NULL };
+
/* Initialize NAND flash access */
int bcma_nflash_init(struct bcma_drv_cc *cc)
{
struct bcma_bus *bus = cc->core->bus;
+ u32 reg;
if (bus->chipinfo.id != BCMA_CHIP_ID_BCM4706 &&
cc->core->id.rev != 38) {
@@ -33,8 +43,16 @@ int bcma_nflash_init(struct bcma_drv_cc *cc)
cc->nflash.present = true;
if (cc->core->id.rev == 38 &&
- (cc->status & BCMA_CC_CHIPST_5357_NAND_BOOT))
+ (cc->status & BCMA_CC_CHIPST_5357_NAND_BOOT)) {
cc->nflash.boot = true;
+ /* Determine the chip select that is being used */
+ reg = bcma_cc_read32(cc, BCMA_CC_NAND_CS_NAND_SELECT) & 0xff;
+ cc->nflash.brcmnand_info.chip_select = ffs(reg) - 1;
+ cc->nflash.brcmnand_info.part_probe_types = probes;
+ cc->nflash.brcmnand_info.ecc_stepsize = 512;
+ cc->nflash.brcmnand_info.ecc_strength = 1;
+ bcma_nflash_dev.name = bcma_nflash_alt_name;
+ }
/* Prepare platform device, but don't register it yet. It's too early,
* malloc (required by device_private_init) is not available yet. */
diff --git a/include/linux/bcma/bcma_driver_chipcommon.h b/include/linux/bcma/bcma_driver_chipcommon.h
index d35b9206096d..e3314f746bfa 100644
--- a/include/linux/bcma/bcma_driver_chipcommon.h
+++ b/include/linux/bcma/bcma_driver_chipcommon.h
@@ -3,6 +3,7 @@
#define LINUX_BCMA_DRIVER_CC_H_
#include <linux/platform_device.h>
+#include <linux/platform_data/brcmnand.h>
#include <linux/gpio.h>
/** ChipCommon core registers. **/
@@ -599,6 +600,10 @@ struct bcma_sflash {
#ifdef CONFIG_BCMA_NFLASH
struct bcma_nflash {
+ /* Must be the fist member for the brcmnand driver to
+ * de-reference that structure.
+ */
+ struct brcmnand_platform_data brcmnand_info;
bool present;
bool boot; /* This is the flash the SoC boots from */
};
diff --git a/include/linux/platform_data/brcmnand.h b/include/linux/platform_data/brcmnand.h
new file mode 100644
index 000000000000..8b8777985dce
--- /dev/null
+++ b/include/linux/platform_data/brcmnand.h
@@ -0,0 +1,12 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+#ifndef BRCMNAND_PLAT_DATA_H
+#define BRCMNAND_PLAT_DATA_H
+
+struct brcmnand_platform_data {
+ int chip_select;
+ const char * const *part_probe_types;
+ unsigned int ecc_stepsize;
+ unsigned int ecc_strength;
+};
+
+#endif /* BRCMNAND_PLAT_DATA_H */
--
2.25.1
